MB39A132QN-G-ERE1 Datasheet, PDF (50/56 Pages) Fujitsu Component Limited. – ASSP For Power Management Applications (Rechargeable Battery) Synchronous Rectification DC/DC Converter IC for Charging Li-ion Battery

MB39A132
■ USAGE PRECAUTION
1. Do not configure the IC over the maximum ratings
If the lC is used over the maximum ratings, the LSl may be permanently damaged.
It is preferable for the device to be normally operated within the recommended usage conditions. Usage
outside of these conditions can have a bad effect on the reliability of the LSI.
2. Use the devices within recommended operating conditions
The recommended operating conditions are the recommended values that guarantee the normal operations
of LSI.
The electrical ratings are guaranteed when the device is used within the recommended operating conditions
and under the conditions stated for each item.
3. Printed circuit board ground lines should be set up with consideration for common
impedance
4. Take appropriate measures against static electricity
• Containers for semiconductor materials should have anti-static protection or be made of conductive ma-
terial.
• After mounting, printed circuit boards should be stored and shipped in conductive bags or containers.
• Work platforms, tools, and instruments should be properly grounded.
• Working personnel should be grounded with resistance of 250 kΩ to 1 MΩ in series between body and
ground.
5. Do not apply negative voltages
The use of negative voltages below −0.3 V may cause the parasitic transistor to be activated on LSI lines,
which can cause malfunctions.
■ ORDERING INFORMATION
Part number
MB39A132QN
Package
32-pin plastic QFN
(LCC-32P-M17)
Remarks
■ EV BOARD ORDERING INFORMATION
EV board part No.
EV board version No.
MB39A132EVB-02
Board rev.2.0
Remarks
QFN-32
■ RoHS COMPLIANCE INFORMATION OF LEAD (Pb) FREE VERSION
The LSI products of Fujitsu Microelectronics with “E1” are compliant with RoHS Directive, and has
observed the standard of lead, cadmium, mercury, hexavalent chromium, polybrominated biphenyls (PBB) ,
and polybrominated diphenyl ethers (PBDE) .
A products whose part number has trailing characters “E1” is RoHS compliant.
50
DS04–27265–3E