MC9RS08LA8 Datasheet, PDF (9/34 Pages) Freescale Semiconductor, Inc – MCU Block Diagram

Electrical Characteristics
(if PI/O is neglected) is:
P_D = K ÷ (T_J + 273°C)
Solving Equation 1 and Equation 2 for K gives:
Eqn. 2
K = P_D × (T_A + 273°C) + θ_JA× (PD)²
Eqn. 3
where K is a constant pertaining to the particular part. K can be determined from Equation A-3 by
measuring P_D (at equilibrium) for a known T_A. Using this value of K, the values of P_D and T_J can be
obtained by solving equations 1 and 2 iteratively for any value of T_A.
3.4 ESD Protection and Latch-Up Immunity
Although damage from electrostatic discharge (ESD) is much less common on these devices than on early
CMOS circuits, normal handling precautions must be used to avoid exposure to static discharge.
Qualification tests are performed to ensure that these devices can withstand exposure to reasonable levels
of static without suffering any permanent damage.
All ESD testing is in conformity with AEC-Q100 Stress Test Qualification for Automotive Grade
Integrated Circuits. During the device qualification ESD stresses were performed for the human body
model (HBM), the machine model (MM) and the charge device model (CDM).
A device is defined as a failure if after exposure to ESD pulses the device no longer meets the device
specification. Complete DC parametric and functional testing is performed per the applicable device
specification at room temperature followed by hot temperature, unless specified otherwise in the device
specification.
Table 5. ESD and Latch-up Test Conditions
Model
Human
Body
Machine
Latch-up
Description
Series resistance
Storage capacitance
Number of pulses per pin
Series resistance
Storage capacitance
Number of pulses per pin
Minimum input voltage limit
Maximum input voltage limit
Symbol
R1
C
—
R1
C
—
—
—
Value
1500
100
3
0
200
3
–2.5
7.5
Unit
Ω
pF
—
Ω
pF
—
V
V
MC9RS08LA8 Series MCU Data Sheet, Rev. 1
Freescale Semiconductor
9