SPC5607BF1MLU6 Datasheet, PDF (84/110 Pages) Freescale Semiconductor, Inc – Microcontroller Data Sheet

Electrical characteristics
4.18 On-chip peripherals
4.18.1 Current consumption
Table 46. On-chip peripherals current consumption¹
Symbol
C
Parameter
Conditions
Typical value² Unit
I_{DD_BV(CAN)} CC T CAN (FlexCAN)
supply current on
V_{DD_BV}
Bitrate:
500 Kbyte/s
Bitrate:
125 Kbyte/s
Total (static + dynamic)
consumption:
8 * f_periph + 85 µA
• FlexCAN in loop-back
mode
8 * f_periph + 27
• XTAL at 8 MHz used as
CAN engine clock source
• Message sending period is
580 µs
I_{DD_BV(eMIOS)} CC T eMIOS supply current Static consumption:
on V_{DD_BV}
• eMIOS channel OFF
• Global prescaler enabled
29 * f_periph µA
Dynamic consumption:
3
• It does not change varying the frequency
(0.003 mA)
I_{DD_BV(SCI)} CC T SCI (LINFlex) supply Total (static + dynamic) consumption:
current on V_{DD_BV}
• LIN mode
• Baudrate: 20 Kbyte/s
5 * f_periph + 31 µA
I_{DD_BV(SPI)} CC T SPI (DSPI) supply
current on V_{DD_BV}
Ballast static consumption (only clocked)
Ballast dynamic consumption (continuous
communication):
• Baudrate: 2 Mbit/s
• Trasmission every 8 µs
• Frame: 16 bits
1
µA
16 * f_periph
I_{DD_BV} CC T ADC_0/ADC_1 supply V_DD = 5.5 V
(ADC_0/ADC_1)
current on V_{DD_BV}
Ballast static consumption
(no conversion)³
41 * f_periph µA
Ballast dynamic consumption 46 * f_periph
(continuous conversion)³
I_{DD_HV_ADC0} CC T ADC_0 supply current V_DD = 5.5 V
on V_{DD_HV_ADC0}
Analog static consumption
(no conversion)
200
µA
Analog dynamic consumption
3
mA
(continuous conversion)
I_{DD_HV_ADC1} CC T ADC_1 supply current V_DD = 5.5 V
on V_{DD_HV_ADC1}
Analog static consumption
(no conversion)
300 * f_periph µA
Analog dynamic consumption
4
mA
(continuous conversion)
I_{DD_HV(FLASH)} CC T CFlash + DFlash
supply current on
V_{DD_HV}
V_DD = 5.5 V
I_{DD_HV(PLL)} CC T PLL supply current on V_DD = 5.5 V
V_{DD_HV}
—
12
mA
—
30 * f_periph µA
MPC5607B Microcontroller Data Sheet, Rev. 6
84
Freescale Semiconductor