SPC5607BF1MLU6 Datasheet, PDF (1/110 Pages) Freescale Semiconductor, Inc – Microcontroller Data Sheet

Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MPC5607B
Rev. 6, 07/2011
MPC5607B
100 LQFP
14 mm x 14 mm
144 LQFP
20 mm x 20 mm
MPC5607B Microcontroller
Data Sheet
176 LQFP
24 mm x 24 mm
208 MAPBGA
17 mm x 17 mm
• Single issue, 32-bit CPU core complex (e200z0h)
– Compliant with the Power Architecture^® technology
embedded category
– Enhanced instruction set allowing variable length
encoding (VLE) for code size footprint reduction. With
the optional encoding of mixed 16-bit and 32-bit
instructions, it is possible to achieve significant code
size footprint reduction.
• Up to 1.5 MB on-chip code flash memory supported with
the flash memory controller
• 64 (4 × 16) KB on-chip data flash memory with ECC
• Up to 96 KB on-chip SRAM
• Memory protection unit (MPU) with 8 region descriptors
and 32-byte region granularity on certain family members
(Refer to Table 1 for details.)
• Interrupt controller (INTC) capable of handling 204
selectable-priority interrupt sources
• Frequency modulated phase-locked loop (FMPLL)
• Crossbar switch architecture for concurrent access to
peripherals, Flash, or RAM from multiple bus masters
• 16-channel eDMA controller with multiple transfer request
sources using DMA multiplexer
• Boot assist module (BAM) supports internal Flash
programming via a serial link (CAN or SCI)
• Timer supports I/O channels providing a range of 16-bit
input capture, output compare, and pulse width modulation
functions (eMIOS)
• 2 analog-to-digital converters (ADC): one 10-bit and one
12-bit
• Cross Trigger Unit to enable synchronization of ADC
conversions with a timer event from the eMIOS or PIT
• Up to 6 serial peripheral interface (DSPI) modules
• Up to 10 serial communication interface (LINFlex)
modules
• Up to 6 enhanced full CAN (FlexCAN) modules with
configurable buffers
• 1 inter-integrated circuit (I²C) interface module
• Up to 149 configurable general purpose pins supporting
input and output operations (package dependent)
• Real-Time Counter (RTC)
– Clock source from internal 128 kHz or 16 MHz
oscillator supporting autonomous wakeup with 1 ms
resolution with maximum timeout of 2 seconds
– Optional support for RTC with clock source from
external 32 kHz crystal oscillator, supporting wakeup
with 1 sec resolution and maximum timeout of 1 hour
• Up to 8 periodic interrupt timers (PIT) with 32-bit counter
resolution
• Nexus development interface (NDI) per IEEE-ISTO
5001-2003 Class Two Plus
• Device/board boundary scan testing supported per Joint
Test Action Group (JTAG) of IEEE (IEEE 1149.1)
• On-chip voltage regulator (VREG) for regulation of input
supply for all internal levels
© Freescale Semiconductor, Inc., 2010-2011. All rights reserved.