English
Language : 

33811 Datasheet, PDF (6/18 Pages) Freescale Semiconductor, Inc – Solenoid Monitor Integrated Circuit (IC)
ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
Characteristics noted under conditions 7.0V ≤ VPWR ≤ 17V, -40°C ≤ TA ≤ 125°C, GND = 0V, unless otherwise noted. Typical
values noted reflect the approximate parameter means at TA = 25°C under nominal conditions, unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
POWER INPUT (VPWR, IPWR, IVDD, VDD, IDD)
Analog Supply Voltage Range
Fully Operational
VPWR (FO)
10.5
–
15.5
V
Digital Logic Supply Voltage Range
Fully Operational
VDD (FO)
4.75
5.0
5.25
V
SPI Voltage Supply Voltage Range
Fully Operational
3.3
VSPI(FO)
3.0
5.0
5.25
V
Supply Current from VPWR
All Outputs Disabled (Normal & Default Mode) VPWR = 17V
IPWR (ON)
–
1.0
5.0
mA
Supply Current from VDD
All Outputs Disabled (Normal & Default Mode) VDD = 5.5V
IDD (ON)
1.0
5.0
mA
Positive Threshold Voltage Point A (10.5V < = VPWR < = 15.5V)
Positive Threshold Voltage Point A with Offset
(10.5V < = VPWR < = 15.5V)
V+TH_A
0
V+TH_A_OFFSET
0.5
1.0
mV
1.5
mV
Positive Threshold Voltage Point B(10.5V < = VPWR < = 15.5V)
Negative Threshold Voltage (10.5V < = VPWR < = 15.5V)
Negative Threshold Voltage with Offset
(10.5V < = VPWR < = 15.5V)
V+TH_B
1.5
3.0
4.5
mV
V-TH
0
-0.5
-1.0
mV
V-TH_OFFSET
-1.5
mV
Logic Supply Voltage
Logic Supply Current
Static Condition
VDD
3.0
–
5.5
V
IDD
µA
250
400
700
SPI DIGITAL INTERFACE (VIH, VIL, VHYS, CIN, LOGICSS)
Input Logic High-voltage Thresholds (8)
Input Logic Low-voltage Thresholds (8)
Input Logic Voltage Hysteresis (8)
Input Logic Capacitance (9)
VIH
VIL
VHYS
CIN
0.7 x VSPI
–
VSPI + 0.3
V
GND - 0.3
–
0.2 x VSPI
V
100
–
300
mV
–
–
20
pF
Notes
6. Output fault detection thresholds with outputs programmed OFF. Output fault detect thresholds are the same for output open and shorts.
7. This parameter is guaranteed by design, however is not production tested.
8. Parameter applies to SI, RESET, CS and is guaranteed by design.
9. Undervoltage thresholds minimum and maximum include hysteresis.
33811
6
Analog Integrated Circuit Device Data
Freescale Semiconductor