908E425 Datasheet, PDF (41/49 Pages) Freescale Semiconductor, Inc – Integrated Quad Half H-Bridge with Power Supply, Embedded MCU, and LIN Serial Communication

TYPICAL APPLICATIONS
EMC/EMI RECOMMENDATIONS
This paragraph gives some device specific
recommendations to improve EMC/EMI performance.
Further generic design recommendations can be e.g. found
on the Freescale web site www.freescale.com.
VSUP PINS (VSUP1:VSUP3)
Its recommended to place a high-quality ceramic
decoupling capacitor close to the VSUP pins to improve
EMC/EMI behavior.
LIN PIN
For DPI (Direct Power Injection) and ESD (Electro Static
Discharge) its recommended to place a high-quality ceramic
decoupling capacitor near the LIN pin. An additional varistor
will further increase the immunity against ESD. A ferrite in the
LIN line will suppress some of the noise induced.
VOLTAGE REGULATOR OUTPUT PINS (VDD AND
AGND)
Use a high-quality ceramic decoupling capacitor to
stabilize the regulated voltage.
MCU DIGITAL SUPPLY PINS (EVDD AND EVSS)
Fast signal transitions on MCU pins place high, short-
duration current demands on the power supply. To prevent
noise problems, take special care to provide power supply
bypassing at the MCU. It is recommended that a high-quality
ceramic decoupling capacitor be placed between these pins.
MCU ANALOG SUPPLY PINS (VREFH, VDDA AND
VREFL, VSSA)
To avoid noise on the analog supply pins its important to
take special care on the layout. The MCU digital and analog
supplies should be tied to the same potential via separate
traces and connected to the voltage regulator output.
Figure 25 and Figure 26 show the recommendations on
schematics and layout level and Table 13 indicates
recommended external components and layout
considerations.
VSUP
D1
+
C1
C2
L1
LIN
V1
C5
VSUP1
VSUP2
VSUP3
LIN
VDD
VSS
VREFH
VDDA
EVDD
C3
C4
EVSS
M^MM^M9⁹0⁰8⁸E^E6⁴2²5⁵
VSSA
GND1
VREFL
GND2
Figure 25. EMC/EMI recommendations
Analog Integrated Circuit Device Data
Freescale Semiconductor
908E425
41