|
MC9S08QD4_10 Datasheet, PDF (3/198 Pages) Freescale Semiconductor, Inc – HCS08 Microcontrollers | |||
|
◁ |
MC9S08QD4 Series Features
8-Bit HCS08 Central Processor Unit (CPU)
⢠Flash block protect
⢠16 MHz HCS08 CPU (central processor
unit)
⢠HC08 instruction set with added BGND
instruction
⢠Background debugging system
⢠Breakpoint capability to allow single
breakpoint setting during in-circuit
debugging (plus two more breakpoints in
on-chip debug module)
⢠Support for up to 32 interrupt/reset sources
Memory
⢠Flash read/program/erase over full
operating voltage and temperature
⢠Flash size:
â MC9S08QD4/S9S08QD4: 4096 bytes
â MC9S08QD2/S9S08QD2: 2048 bytes
⢠RAM size
â MC9S08QD4/S9S08QD4: 256 bytes
â MC9S08QD2/S9S08QD2: 128 bytes
Power-Saving Modes
⢠Wait plus three stops
Clock Source Options
⢠ICS â Internal clock source module (ICS)
containing a frequency-locked-loop (FLL)
controlled by internal. Precision trimming
of internal reference allows 0.2% resolution
and 2% deviation over temperature and
voltage.
System Protection
Peripherals
⢠ADC â 4-channel, 10-bit analog-to-digital
converter with automatic compare
function, asynchronous clock source,
temperature sensor and internal bandgap
reference channel. ADC is hardware
triggerable using the RTI counter.
⢠TIM1 â 2-channel timer/pulse-width
modulator; each channel can be used for
input capture, output compare, buffered
edge-aligned PWM, or buffered
center-aligned PWM
⢠TIM2 â 1-channel timer/pulse-width
modulator; each channel can be used for
input capture, output compare, buffered
edge-aligned PWM, or buffered
center-aligned PWM
⢠KBI â 4-pin keyboard interrupt module
with software selectable polarity on edge or
edge/level modes
Input/Output
⢠Four General-purpose input/output (I/O)
pins, one input-only pin and one
output-only pin. Outputs 10 mA each, 60
mA maximum for package.
⢠Software selectable pullups on ports when
used as input
⢠Software selectable slew rate control and
drive strength on ports when used as output
⢠Internal pullup on RESET and IRQ pin to
reduce customer system cost
Development Support
⢠Watchdog computer operating properly
(COP) reset with option to run from
dedicated 32 kHz internal clock source or
bus clock
⢠Low-voltage detection with reset or
interrupt
⢠Illegal opcode detection with reset
⢠Illegal address detection with reset
⢠Single-wire background debug interface
Package Options
⢠8-pin SOIC package
⢠8-pin PDIP (Only for MC9S08QD4 and
MC9S08QD2)
⢠All package options are RoHS compliant
|
▷ |