MFR4300_07 Datasheet, PDF (245/266 Pages) Freescale Semiconductor, Inc – FlexRay Communication Controllers

Electrical Characteristics
Table A-7. 3.3V I/O Characteristics (V_DD5 = 3.3V) (Continued)
Conditions are V_DDX=3.3V ±10% Temperature from –40^oC to +140^oC, unless otherwise noted
Num C
Rating
Symbol
Min
Typ
Max
Unit
6
P Output High Voltage (pins in output mode)
@100% Full Drive I_OH = –4.5mA
7
P Output Low Voltage (pins in output mode)
@50% Partial Drive I_OL = +0.9mA
8
P Output Low Voltage (pins in output mode)
@100% Full Drive I_OL = +5.5mA
9
P Internal Pullup Device Current,
tested at V_IL Max
10 P Internal Pullup Device Current,
tested at V_IH Min.
11 P Internal Pulldown Device Current,
tested at V_IH Min.
12 P Internal Pulldown Device Current,
tested at V_IL Max
13 D Input Capacitance (input, input/output
pins)
14
T Injection Current¹
Single Pin Limit
Total Device Limit. Sum of all injected currents
15 P Load Capacitance
50% Partial Drive
100% Full Drive
1 _{Refer to Section A.1.4, “Current Injection” for more information.}
V_OH
V_OL
V_OL
I_PUL
I_PUH
I_PDH
I_PDL
C_IN
I_ICS
I_ICP
C_L
V_DD5 –0.4
—
—
—
—
—
—
—
–6
—
—
—
6
—
—
7
–2.5
—
–25
—
—
—
—
V
0.4
V
0.4
V
–60
uA
—
uA
60
uA
—
uA
—
pF
mA
2.5
25
pF
25
50
A.1.10 Supply Currents
All measurements are done without output loads. Unless otherwise noted, the currents are measured with
internal voltage regulator enabled and a 40 MHz oscillator, in standard Pierce mode. Production testing is
performed using a square wave signal at the EXTAL input.
Table A-8. Supply Current Characteristics
Conditions are shown in Table A-4 unless otherwise noted
Num C
Rating
Symbol
Min
Typ
Max
Unit
1 P Run supply currents
–40°C
I_DD5
—
Internal regulator enabled
25°C
—
140°C
—
—
TBD
mA
—
TBD
—
TBD
MFR4300 Data Sheet, Rev. 3
Freescale Semiconductor
245