English
Language : 

MCF53017_10 Datasheet, PDF (22/62 Pages) Freescale Semiconductor, Inc – Version 3 ColdFire® core with EMAC
Preliminary Electrical Characteristics
Table 10. DC Electrical Specifications (continued)
Characteristic
Symbol
Min
Max
Unit
SDRAM and FlexBus Output High Voltage
Mobile DDR/Bus Input High Voltage (nominal 1.8V)
DDR/Bus Pad Supply Voltage (nominal 2.5V)
SDR/Bus Pad Supply Voltage (nominal 3.3V)
IOH = –5.0 mA for all modes
SDVOH
V
SDVDD × 0.9
—
SDVDD – 0.35
—
2.9
—
SDRAM and FlexBus Output Low Voltage
Mobile DDR/Bus Input High Voltage (nominal 1.8V)
DDR/Bus Pad Supply Voltage (nominal 2.5V)
SDR/Bus Pad Supply Voltage (nominal 3.3V)
IOL = 5.0 mA for all modes
SDVOL
V
—
SDVDD × 0.1
—
0.35
—
0.4
Input Leakage Current
Vin = VDD or VSS, Input-only pins
Weak Internal Pull-Up/Pull-down Device Current1
Selectable Weak Internal Pull-Up/Pull-down Device Current2
Input Capacitance 3
All input-only pins
All input/output (three-state) pins
Iin
IAPU
IAPU
Cin
–2.5
10
25
—
—
2.5
μA
315
μA
150
μA
pF
7
7
1 Refer to the signals section for pins having weak internal pull-up devices.
2 Refer to the signals section for pins having weak internal pull-up devices.
3 This parameter is characterized before qualification rather than 100% tested.
5.4.1 PLL Power Filtering
To further enhance noise isolation, an external filter is strongly recommended for PLL analog VDD pins. The filter shown in
Figure 8 should be connected between the board VDD and the PLLVDD pins. The resistor and capacitors should be placed as
close to the dedicated PLLVDD pin as possible.
Board IVDD
10 Ω
PLL VDD Pin
10 µF
0.1 µF
GND
Figure 8. System PLL VDD Power Filter
5.4.2 USB Power Filtering
To minimize noise, external filters are required for each of the USB power pins. The filter shown in Figure 2 should be
connected between the board EVDD or IVDD and each of the USBVDD pins. The resistor and capacitors should be placed as
close to the dedicated USBVDD pin as possible.
MCF5301x Data Sheet, Rev. 5
22
Preliminary—Subject to Change Without Notice
Freescale Semiconductor