56F803_07 Datasheet, PDF (21/52 Pages) Freescale Semiconductor, Inc – 16-bit Digital Signal Controllers

DC Electrical Characteristic
Table 3-4 DC Electrical Characteristics (Continued)
Operating Conditions: V_SS = V_SSA = 0 V, V_DD = V_DDA = 3.0–3.6 V, T_A = –40° to +85°C, C_L ≤ 50pF, f_op = 80MHz
Characteristic
Symbol
Min
Typ
Max
Unit
Input current high (analog inputs, V_IN=V_DDA)²
Input current low (analog inputs, V_IN=V_SSA)²
Output High Voltage (at IOH)
Output Low Voltage (at IOL)
Output source current
Output sink current
PWM pin output source current³
I_IHA
I_ILA
V_OH
V_OL
I_OH
I_OL
I_OHP
-15
—
15
μA
-15
—
15
μA
V_DD – 0.7 —
—
V
—
—
0.4
V
4
—
—
mA
4
—
—
mA
10
—
—
mA
PWM pin output sink current⁴
Input capacitance
Output capacitance
V_DD supply current
Run ⁶
I_OLP
C_IN
C_OUT
I_DDT5
16
—
—
mA
—
8
—
pF
—
12
—
pF
—
126
152
mA
Wait⁷
—
105
129
mA
Stop
—
60
84
mA
Low Voltage Interrupt, external power supply⁸
V_EIO
2.4
2.7
3.0
V
Low Voltage Interrupt, internal power supply⁹
V_EIC
2.0
2.2
2.4
V
Power on Reset¹⁰
V_POR
—
1.7
2.0
V
1.
1. Schmitt Trigger inputs are: EXTBOOT, IRQA, IRQB, RESET, ISA0-2, FAULTA0-3, TCS, TCK, TRST, TMS, TDI, and
MSCAN_RX
2. Analog inputs are: ANA[0:7], XTAL and EXTAL. Specification assumes ADC is not sampling.
3. PWM pin output source current measured with 50% duty cycle.
4. PWM pin output sink current measured with 50% duty cycle.
5. I_DDT = I_DD + I_DDA (Total supply current for V_DD + V_DDA)
6. Run (operating) I_DD measured using 8MHz clock source. All inputs 0.2V from rail; outputs unloaded. All ports configured
as inputs; measured with all modules enabled.
7. Wait I_DD measured using external square wave clock source (f_osc = 8MHz) into XTAL; all inputs 0.2V from rail; no DC
loads; less than 50pF on all outputs. C_L = 20pF on EXTAL; all ports configured as inputs; EXTAL capacitance linearly affects
wait I_DD; measured with PLL enabled.
56F803 Technical Data, Rev. 16
Freescale Semiconductor
21