|
MC9S08QE8_09 Datasheet, PDF (12/46 Pages) Freescale Semiconductor, Inc – 8-Bit HCS08 Central Processor Unit | |||
|
◁ |
Electrical Characteristics
Table 7. DC Characteristics (continued)
Num C
Characteristic
Symbol
Condition
Min. Typical1 Max. Unit
Pullup,
12b C pulldown
RPU,
(PTA5/IRQ/TCLK/RESET) RPD
resistors
â
(Note3)
17.5
â
52.5
kΩ
DC injection
Single pin limit
â0.2
â
13 C current 4, 5, Total MCU limit, includes IIC VIN < VSS, VIN > VDD
6
sum of all stressed pins
â5
â
0.2
mA
5
mA
14 C Input capacitance, all pins
CIn
â
â
â
8
pF
15 C RAM retention voltage
16 C POR re-arm voltage7
VRAM
â
VPOR
â
â
0.6
1.0
V
0.9
1.4
2.0
V
17 D POR re-arm time
tPOR
â
10
â
â
μs
18 P Low-voltage detection threshold
VLVD
VDD falling
VDD rising
1.80
1.88
1.84
1.92
1.88
1.96
V
19 P Low-voltage warning threshold
VLVW
VDD falling
VDD rising
2.08
2.14
2.24
V
20
P
Low-voltage inhibit reset/recover
hysteresis
Vhys
â
â
80
â
mV
21 P Bandgap voltage reference8
VBG
â
1.15
1.17
1.18
V
1 Typical values are measured at 25 °C. Characterized, not tested
2 As the supply voltage rises, the LVD circuit will hold the MCU in reset until the supply has risen above VLVDL.
3 The specified resistor value is the actual value internal to the device. The pullup or pulldown value may appear higher when
measured externally on the pin.
4 All functional non-supply pins, except for PTA5 are internally clamped to VSS and VDD.
5 Input must be current limited to the value specified. To determine the value of the required current-limiting resistor, calculate
resistance values for positive and negative clamp voltages, then use the larger of the two values.
6 Power supply must maintain regulation within operating VDD range during instantaneous and operating maximum current
conditions. If the positive injection current (VIn > VDD) is greater than IDD, the injection current may flow out of VDD and could
result in external power supply going out of regulation. Ensure that external VDD load will shunt current greater than maximum
injection current. This will be the greatest risk when the MCU is not consuming power. Examples are: if no system clock is
present, or if clock rate is very low (which would reduce overall power consumption).
7 Maximum is highest voltage that POR is guaranteed.
8 Factory trimmed at VDD = 3.0 V, Temp = 25 °C
MC9S08QE8 Series Data Sheet, Rev. 7
12
Freescale Semiconductor
|
▷ |