|
MC9S08QA4 Datasheet, PDF (1/32 Pages) Freescale Semiconductor, Inc – 8-bit HCS08 Central Processor Unit (CPU) | |||
|
Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MC9S08QA4
Rev. 2, 2/2008
MC9S08QA4
8-Pin DFN
Case 1452-02
8-Pin NB-SOIC
Case 751-07
MC9S08QA4 Series
Covers: MC9S08QA4
8-Pin PDIP
Case 626-06
Features:
⢠8-bit HCS08 Central Processor Unit (CPU)
â Up to 20 MHz CPU at 3.6 V to 1.8 V across temperature
range of â40°C to 85°C
â HC08 instruction set with added BGND instruction
â Support for up to 32 interrupt/reset sources
⢠On-Chip Memory
â Flash read/program/erase over full operating voltage
and temperature
â Random-access memory (RAM)
â Security circuitry to prevent unauthorized access to
RAM and flash contents
⢠Power-Saving Modes
â Two very low power stop modes
â Peripheral clock enable register can disable clocks to
unused modules, thereby reducing currents
â Very low power real time counter for use in run, wait,
and stop modes with internal clock sources
⢠Clock Source Options
â Internal Clock Source (ICS) â Internal clock source
module containing a frequency-locked-loop (FLL)
controlled by internal reference; precision trimming of
internal reference allows 0.2% resolution and 2%
deviation over temperature and voltage; supports bus
frequencies from 1 MHz to 10 MHz
⢠System Protection
â Watchdog computer operating properly (COP) reset
with option to run from dedicated 1 kHz internal clock
source or bus clock
â Low-voltage detection with reset or interrupt
â Selectable trip points
â Illegal opcode detection with reset
â Illegal address detection with reset
â Flash block protection
⢠Development Support
â Single-wire background debug interface
â Breakpoint capability to allow single breakpoint setting
during in-circuit debugging
⢠Peripherals
â ADC â 4-channel, 10-bit resolution; 1.7 mV/°C
temperature sensor; automatic compare function;
internal bandgap reference channel; operation in stop3;
fully functional from 3.6 V to 1.8 V
â ACMP â Analog comparator with selectable interrupt
on rising, falling, or either edge of comparator output;
compare option to fixed internal bandgap reference
voltage; output can be tied internally to TPM input
capture
â TPM â One 1-channel timer/pulse-width modulator
(TPM) module; selectable input capture, output
compare, or buffered edge- or center-aligned PWM on
each channel; ACMP output can be tied internally to
input capture
â MTIM â 8-bit modulo timer module with 8-bit
prescaler
â KBI â 4-pin keyboard interrupt module with software
selectable polarity on edge or edge/level modes
⢠Input/Output
â Four GPIOs, one input-only pin and one output-only
pin.
â Hysteresis and configurable pullup device on all input
pins; configurable slew rate and drive strength on all
output pins except PTA5
⢠Package Options
â 8-pin SOIC, PDIP, and DFN
This document contains information on a product under development. Freescale reserves the
right to change or discontinue this product without notice.
© Freescale Semiconductor, Inc., 2008. All rights reserved.
|
▷ |