FR011L5J Datasheet, PDF (3/12 Pages) Fairchild Semiconductor – Low-Side Reverse Bias Reverse Polarity Protector

Absolute Maximum Ratings
Values are at TA=25°C unless otherwise noted.
Symbol
Parameter
Values
Unit
V+ _{MAX_OP}
Steady-State Normal Operating Voltage between CTL and NEG Pins
(VIN = V+ MAX_OP, IIN = 1.5A, Switch On)
+20
V+ 24
24-Hour Normal Operating Voltage Withstand Capability between CTL and
NEG Pins (V_IN = V+ ₂₄, I_IN = 1.5A, Switch On)
+29
V
V- _{MAX_OP}
Steady-State Reverse Bias Standoff Voltage between CTL and NEG Pins
(VIN = V- MAX_OP)
-30
IIN
Input Current
Continuous⁽²⁾ (see Figure 4)
11
A
T_J
Operating Junction Temperature
PD
Power Dissipation
T_A = 25°C⁽²⁾ (see Figure 4)
T_A = 25°C⁽²⁾ (see Figure 5)
150
°C
2.4
W
0.9
IDIODE_CONT Steady-State Diode Continuous Forward Current from POS to NEG
IDIODE_PULSE Pulsed Diode Forward Current from POS to NEG (300µs Pulse)
2
A
210
Human Body Model, JESD22-A114
0.6
ESD
Electrostatic Discharge
Capability
Charged Device Model, JESD22-C101
System Model, IEC61000-4-2 ^Contact
2
kV
8
(CTL is shorted to POS)⁽³⁾
Air
15
Notes:
1. The V₊₂₄ rating is NOT a survival guarantee. It is a statistically calculated survivability reference point taken on
qualification devices, where the predicted failure rate is less than 0.01% at the specified voltage for 24 hours. It is
intended to indicate the device’s ability to withstand transient events that exceed the recommended operating
voltage rating. Specification is based on qualification devices tested using accelerated destructive testing at
higher voltages, as well as production pulse testing at the V₊₂₄ level. Production device field life results may vary.
Results are also subject to variation based on implementation, environmental considerations, and circuit
dynamics. Systems should never be designed with the intent to normally operate at V+24 levels. Contact Fairchild
Semiconductor for additional information.
2. The device power dissipation and thermal resistance (R_θ) are characterized with device mounted on the following
FR4 printed circuit boards, as shown in Figure 4 and Figure 5
3. Conducted with shorted load. Open load performance is not guaranteed.
Figure 4. 1 Square Inch of 2-ounce copper
Figure 5. Minimum Pads of 2-ounce Copper
Thermal Characteristics
Symbol
RθJA
R_θJA
Parameter
Thermal Resistance, Junction to Ambient⁽²⁾ (see Figure 4)
Thermal Resistance, Junction to Ambient⁽²⁾ (see Figure 5)
© 2012 Fairchild Semiconductor Corporation
FR011L5J • Rev. C2
3
Value
61
153
Unit
°C/W
www.fairchildsemi.com