461960 Datasheet, PDF (6/10 Pages) Extech Instruments Corporation. – RPM Controller / Monitor

1st layer setting procedures
CtSP
Control value setting
LoLt
Low limit value setting
HILt
High limit value setting
Control Value Setting
1. Press the "Set” button" once, the display will show " CtSP ", the meter is now ready
for the " Control value " setting.
2. Use the "▼” button and the "▲” to adjust the desired "Control value".
Note: When adjusting the value, the "SV” indicator will light.
Low Limit Value Setting
1. Press the "Set” button" twice, the display will show " LoLt ", the meter is now ready
for the " Low Limit value " setting.
2. Use the "▼” button and the "▲” to adjust the desired "Low limit value ".
Note: When adjusting the value, the "SV” indicator will light.
High Limit Value Setting
1. After setting the "Low Limit" value, press the "Set” button twice, the display will
show "HILt", the meter is now ready for the humidity "High Limit" value setting.
2. Use the "▼” button and the "▲” to adjust the desired "High limit value ".
Note: When adjusting the value, the "SV” indicator will light.
1st layer setting considerations;
1. Under the normal display, if the "Function” button is set to the "RPM function" and
the "RPM” indicator is on, then the 1st layer setting procedures will ready for the
"RPM" function.
2. Under the normal display, if the " Function” button is set to the "m/min. function",
and the "m/mi” indicator is on, then the 1st layer setting procedures will ready for
"m/min." function.
3. 3) Under the normal display, if the "Function” button is set to the "ft/min. function"
and the "ft/min” indicator " is on, then the 1st layer setting procedures will ready for
"ft/min." function.
6
461960 V1.1 8/07