XR21B1424 Datasheet, PDF (8/61 Pages) Exar Corporation – Enhanced 4-Ch Full-Speed USB UART

XR21B1424
Pin No.
Pin Name
59
GPIOD0/RID#/RWKD#
60
GPIOA9/RXTA
61
GPIOA8/TXTA
62
GPIOA7/RS485A
63
GPIOA6/CLKA
64
TXA
Type
I/O
I/O
I/O
I/O
I/O
O
Description
General purpose I/O, or UART Ring-Indicator input (active low), or Remote Wakeup input.
Defaults to GPIO input with internal pull-up resistor. See “Remote Wakeup” on page 10.
General purpose I/O, or UART receive data indicator. Defaults to GPIO input with internal pull-
up resistor. See “TXT and RXT Pins” on page 19. When configured as receive indicator, this
pin will toggle at ~10Hz intervals while the UART is receiving data.
General purpose I/O, or UART transmit data indicator. Defaults to GPIO input with internal pull-
up resistor. See “TXT and RXT Pins” on page 19. When configured as transmit indicator, this
pin will toggle at ~10Hz intervals while the UART is transmitting data.
General purpose I/O, or auto RS-485 half-duplex control. Defaults to GPIO input with internal
pull-up resistor. See “Multidrop mode with address matching” on page 18.
General purpose I/O, or clock or pulse output. Defaults to GPIO input with internal pull-up
resistor. See “Programmable Output Clock” on page 16.
UART Transmit Data.
Type: I = Input, O = Output, I/O = Input/Output, PWR = Power, OD = Open-Drain
© 2014 Exar Corporation
8 / 61
exar.com/XR21B1424
Rev 1B