XR21V1414IM-0B-EB Datasheet, PDF (6/34 Pages) Exar Corporation – 4-CH FULL-SPEED USB UART

XR21V1414
4-CH FULL-SPEED USB UART
Pin Description
REV. 1.3.0
NAME
GPIOC1/CDC#
GPIOC2/DSRC#
GPIOC3/DTRC#
GPIOC4/CTSC#
GPIOC5/RTSC#/
RS485C
48-QFN
PIN #
28
27
26
25
24
TYPE
DESCRIPTION
I/O _{UART Channel C general purpose I/O or UART Carrier-Detect input}
(active low). This pin has an internal pull-up resistor which is disabled dur-
ing suspend mode. If using this GPIO as an input, an external pull-up
resistor is required to minimize the power consumption in the suspend
mode.
I/O _{UART Channel C general purpose I/O or UART Data-Set-Ready input}
(active low). See ”Section 1.5.6, Automatic DTR/DSR Hardware
Flow Control” on page 13. This pin has an internal pull-up resistor
which is disabled during suspend mode. If using this GPIO as an input, an
external pull-up resistor is required to minimize the power consumption in
the suspend mode.
I/O _{UART Channel C general purpose I/O or UART Data-Terminal-Ready out-}
put (active low). See ”Section 1.5.6, Automatic DTR/DSR Hard-
ware Flow Control” on page 13. This pin has an internal pull-up
resistor which is disabled during suspend mode. If using this GPIO as an
input, an external pull-up resistor is required to minimize the power con-
sumption in the suspend mode.
I/O _{UART Channel C general purpose I/O or UART Clear-to-Send input}
(active low). See ”Section 1.5.5, Automatic RTS/CTS Hardware
Flow Control” on page 13. This pin has an internal pull-up resistor
which is disabled during suspend mode. If using this GPIO as an input, an
external pull-up resistor is required to minimize the power consumption in
the suspend mode.
I/O _{UART Channel C general purpose I/O or UART Request-to-Send output}
(active low) or auto RS-485 half-duplex control. See ”Section 1.5.5,
Automatic RTS/CTS Hardware Flow Control” on page 13. This
pin has an internal pull-up resistor which is disabled during suspend mode.
If using this GPIO as an input, an external pull-up resistor is required to
minimize the power consumption in the suspend mode.
UART Channel D Signals
RXD
39
TXD
38
GPIOD0/RID#/
37
RWKD#
GPIOD1/CDD#
34
I
UART Channel D Receive Data or IR Receive Data. This pin has an inter-
nal pull-up resistor. Internal pull-up resistor is not disabled during suspend
mode.
O _{UART Channel D Transmit Data or IR Transmit Data.}
I/O _{UART Channel D general purpose I/O or UART Ring-Indicator input}
(active low) or Remote Wakeup Input (See ”Section 1.5.12, USB Sus-
pend” on page 14.). This pin has an internal pull-up resistor which is
disabled during suspend mode. If using this GPIO as an input, an external
pull-up resistor is required to minimize the power consumption in the sus-
pend mode.
I/O _{UART Channel D general purpose I/O or UART Carrier-Detect input}
(active low). This pin has an internal pull-up resistor which is disabled dur-
ing suspend mode. If using this GPIO as an input, an external pull-up
resistor is required to minimize the power consumption in the suspend
mode.
6