XR21V1414IM-0B-EB Datasheet, PDF (15/34 Pages) Exar Corporation – 4-CH FULL-SPEED USB UART

XR21V1414
REV. 1.3.0
4-CH FULL-SPEED USB UART
1.5.13 Remote Wakeup
When the V1414 is suspended, the GPIO0/RI#/RWK# pin can be used to request that the host exit the
Suspend state. A high to low transition on this pin will cause the device to signal a remote wakeup request to
the host via a custom driver. Note that the standard CDC-ACM driver does not support this feature. In order for
the remote wakeup to work, several things must be properly configured. First, the GPIO0/RI# pin must be
configured as an input. Additionally, the V1414 device must have the remote wakeup feature support indicated
in the USB attributes - See “Section 1.3, I2C Interface” on page 10. Lastly, the software driver must inform
the USB host that the peripheral device supports the remote wake-up feature.
15