XRT75VL00 Datasheet, PDF (50/50 Pages) Exar Corporation – E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR

XRT75VL00
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.3
REVISION HISTORY
1.0.1 Changed I_CC and P_DD in the electrical characteristics. Removed evaluation schematic. Changed the
MTIP/MRING configuration in Figure 16 (Transmit Driver Monitor Setup).
1.0.2 Changed I_CC and P_DD in the electrical characteristics.
1.0.3 Changed the Device ID to reflect the correct value.
NOTICE
EXAR Corporation reserves the right to make changes to the products contained in this publication in order to
improve design, performance or reliability. EXAR Corporation assumes no responsibility for the use of any
circuits described herein, conveys no license under any patent or other right, and makes no representation that
the circuits are free of patent infringement. Charts and schedules contained here in are only for illustration
purposes and may vary depending upon a user’s specific application. While the information in this publication
has been carefully checked; no responsibility, however, is assumed for inaccuracies.
EXAR Corporation does not recommend the use of any of its products in life support applications where the
failure or malfunction of the product can reasonably be expected to cause failure of the life support system or to
significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless
EXAR Corporation receives, in writing, assurances to its satisfaction that: (a) the risk of injury or damage has
been minimized; (b) the user assumes all such risks; (c) potential liability of EXAR Corporation is adequately
protected under the circumstances.
Copyright 2004 EXAR Corporation
Datasheet February 2004.
Reproduction, in part or whole, without the prior written consent of EXAR Corporation is prohibited.
48