XR22802 Datasheet, PDF (43/46 Pages) Exar Corporation – Hi-Speed USB to 10/100 Ethernet Bridge

XR22802
Bit
8:6
5
4:0
Default
Description
0x0
Cmd
000: Idle. output pin remains at same state
001: Undefined, do not use
010: Undefined, do not use
011: Undefined, do not use
100: Assert logic ‘0’
101: One-shot -If previous state was assert ’0’, one-shot pulse will be high, If previous state was assert ’1’, one-
shot pulse will be low
110: Free run output
111: Assert logic ‘0’
0
Enable
0: PWM0 output is not enabled
1: PWM0 output is enabled on pin specified in Pin field using mode specified in Cmd field
0x00
Pin
Specifies which pin (E31 - E0) will be assigned to PWM0 output.
EDGE_PWM0_HIGH (0x3D9) - Read/Write
Bit
15:12
11:0
Default
Description
0x0
0x001
Reserved
These bits are reserved and should be written as ‘0’.
Value
This register specifies the high period for PWM0 in increments of 266.667ns. High period must be in the range
of 1 to 4095 (266.667 ns to 1.092 ms)
EDGE_PWM0_LOW (0x3DA) - Read/Write
Bit
15:12
11:0
Default
Description
0x0
Reserved
These bits are reserved and should be written as ‘0’.
0x001
Value
This register specifies the low period for PWM0 in increments of 266.667ns. Low period must be in the range of
1 to 4095 (266.667 ns to 1.092 ms)
© 2015 Exar Corporation
43 / 46
exar.com/XR22802
Rev 1B