XR22802 Datasheet, PDF (42/46 Pages) Exar Corporation – Hi-Speed USB to 10/100 Ethernet Bridge

XR22802
EDGE_INTR_MASK_1 (0x3D5) - Read/Write
Bit
31:16
Default
Description
0x0000
E[31:16]
Writing a ’1’ in this register enables an input pin for the corresponding bit position EDGE IO pin(s) configured as
an input to generate an interrupt if either EDGE_INTR_POS_EDGE and / or EDGE _INTR_NEG_EDGE regis-
ters has also been enabled. An EDGE pin configured as an output has no effect.
0: IO pin will not generate an interrupt
1: IO pin assigned to EDGE function and configured as an input will generate an interrupt
EDGE_INTR_POS_EDGE_1 (0x3D6) - Read/Write
Bit
31:16
Default
Description
0xFFFF
E[31:16]
Writing a ’1’ in this register enables an interrupt to be generated on the rising edge of the corresponding bit posi-
tion EDGE IO pin(s) configured as an input if the EDGE_INTR_MASK register is enabled for that pin. If the
EDGE_INTR_NEG_EDGE register is also enabled, interrupts will be generated on both edges. Writing to an
EDGE pin configured as an output has no effect.
0: IO pin will not generate an interrupt on rising edge
1: IO pin assigned to EDGE function and configured as an input will generate an interrupt on rising edge if cor-
responding EDGE_INTR_MASK bit is set
EDGE_INTR_NEG_EDGE_1 (0x3D7) - Read/Write
Bit
31:16
Default
Description
0xFFFF
E[31:16]
Writing a ’1’ in this register enables an interrupt to be generated on the falling edge of the corresponding bit
position EDGE IO pin(s) configured as an input if the EDGE_INTR_MASK register is enabled for that pin. If the
EDGE_INTR_POS_EDGE register is also enabled, interrupts will be generated on both edges. Writing to an
EDGE pin configured as an output has no effect.
0: IO pin will not generate an interrupt on falling edge
1: IO pin assigned to EDGE function and configured as an input will generate an interrupt on falling edge if cor-
responding EDGE_INTR_MASK bit is set
EDGE_PWM0_CTRL (0x3D8) - Read/Write
Bit
15:9
Default
Description
0x00
Reserved
These bits are reserved and should be written as ‘0’.
© 2015 Exar Corporation
42 / 46
exar.com/XR22802
Rev 1B