 English |
|
|
|
|
|
|
|
| XRT75VL00D_08 Datasheet, PDF (41/92 Pages) Exar Corporation – E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET | |||
| |||
| ◁ |
REV. 1.0.4
XRT75VL00D
E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
When the XRT75VL00D is configured in Host mode, the following input pins,TxLEV, TAOS, RLB, LLB, E3,
STS-1/DS3, REQEN, JATx/Rx, JA0 and JA1 are disabled and must be connected to ground.
Table 14 below illustrates the functions of the shared pins in either Host mode or in Hardware mode.
TABLE 14: FUNCTIONS OF SHARED PINS
PIN NUMBER
IN HOST MODE
IN HARDWARE MODE
24
CS
RxClkINV
26
SClk
TxClkINV
25
SDI
RxON
27
SDO
RxMON
28
INT
LOSMUT
NOTE: While configured in Host mode, the TxON input pin will be active if the TxON bit in the control register is set to â1â,
and can be used to turn on and off the transmit output drivers. This permits a system designed for redundancy to
quickly switch out a defective line card and switch-in the backup line card.
TABLE 15: REGISTER MAP AND BIT NAMES
ADDRESS
PARAMETER
DATA BITS
(HEX)
NAME
7
6
5
4
3
2
1
0
0x00
APS/Redundancy Reserved Reserved Reserved
(read/write)
RxON Reserved Reserved Reserved TxON
0x01
Interrupt Enable
(read/write)
Reserved
CNT_SATIE PRBSIE FLIE RLOLIE RLOSIE DMOIE
0x02
Interrupt Status
(reset on read)
Reserved
CNT_SATIS PRBSIS FLIS RLOLIS RLOSIS DMOIS
0x03
Alarm Status Reserved PRBSLS DLOS
ALOS
FL
RLOL RLOS DMO
(read only)
0x04
Transmit Control
(read/write)
Reserved
TxMON INSPRBS Reserved TAOS TxClkINV TxLEV
0x05
Receive Control
(read/write)
Reserved
DLOSDIS ALOSDIS RxClkINV LOSMUT RxMON REQEN
0x06
Block Control
(read/write)
Reserved
PRBSEN RLB
LLB
E3
STS1/ SR/DR
DS3
0x07
Jitter Attenuator
(read/write)
Reserved
DFLCK PNTRST JA1 JATx/Rx JA0
0x08-
0x1F
Reserved
0x20
Interrupt Enable-
Global
(read/write)
Reserved
Reserved Reserved INTEN
0x21
Interrupt Status
(read only)
Reserved
Reserved Reserved INTST
36
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese