SP26LV431 Datasheet, PDF (4/22 Pages) Sipex Corporation – High Speed, +3.3V Quad RS-422 Differential Line Driver

SP26LV431
HIGH SPEED +3.3V QUAD RS-422 DIFFERENTIAL LINE DRIVER
REV. 1.1.0
ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the device at these ratings or any other above those indicated in the operation sections to the
specifications below is not implied. Exposure to absolute maximum rating conditions for extended periods of time may affect reliability and cause permanent
damage to the device.
V_CC
V_IN (DC Input Voltage)
V_OUT (DC Output Voltage)
I_IK, I_OK (Clamp Diode Current)
I_OUT (DC Output Current, per pin)
I_CC (DC V_CC or GND Current, per pin)
Storage Temperature Range
0.5V to 7.0V
-1.5V to (V_CC + 1.5V)
-0.5V to 7V
±20mA
±150mA
±150mA
-65°C to + 150°C
Power Dissipation 16-pin PDIP
(derate 14.3mW/°C above +70°C)
1150mW
Power Dissipation 16-pin NSOIC
(derate 13.6mW/°C above +70°C)
1100mW
CAUTION:
ESD (Electrostatic Discharge) sensitive device. Permanent damage may occur on unconnected devices subject to high energy electrostatic fields. Unused
devices must be stored in conductive foam or shunts. Personnel should be properly grounded prior to handling this device. The protective foam should be
discharged to the destination socket before devices are removed.
ELECTRICAL CHARACTERISTICS
UNLESS OTHERWISE NOTED: THE FOLLOWING SPECIFICATIONS APPLY FOR VCC = +3.0V TO +3.6V WITH TA =
+25^OC AND ALL MIN AND MAX LIMITS APPLY ACROSS THE RECOMMENDED OPERATING TEMPERATURE RANGE.
SYMBOL
PARAMETERS
V_CC
Supply Voltage
V_IN or V_OUT DC Input or Output Voltage
Input Electrical Characteristics
t_r or t_f
Input Rise or Fall Times
V_IH
HIGH Level Input Voltage
V_IL
LOW Level Input Voltage
Output Electrical Characteristics
V_OH
HIGH Level Output Voltage
V_OL
LOW Level Output Voltage
V_T
Differential Output Voltage
VT – VT
Differential Output Voltage
V_OS
Common Mode Output Voltage
VOS – VOS ^{Difference in Common Mode Output}
MIN.
3.0
2.0
2.5
2.0
TYP.
3
2.9
0.2
2.7
MAX. UNITS
3.6
V
VCC V
CONDITIONS
ns
V
0.8
V
V V_IN = V_IH or V_IL, I_OUT = -20mA
0.5
V V_IN = V_IH or V_IL, I_OUT = 20mA
V R_L = 100Ω, Note 1
0.4
V R_L = 100Ω, Note 1
3.0
V R_L = 100Ω, Note 1
0.4
V R_L = 100Ω, Note 1
I_CC
Quiescent Supply Current
100 uA V_IN = V_CC or GND, Note 2
4