SP6213 Datasheet, PDF (3/10 Pages) Sipex Corporation – Micropower, SC-70, 100mA CMOS LDO Regulator

ELECTRICAL CHARACTERISTICS
V_IN = V_OUT +0.5V, I_L = 100µA, C_IN = 1µF, C_OUT = 1µF, T_J = 25^°C , unless otherwise noted. The ♦ denotes the specifications which apply over
the full operating temperature range, unless otherwise specified.
PARAMETER
ENABLE INPUT
Enable Input Logic-Low Voltage, (V_IL)
Enable Input Logic-High Voltage, (V_IH)
Enable Input Current, (I_IL), (I_IH)
MIN
1.6
Turn on Time (T_ON)
Turn off Time (T_OFN)
TYP MAX
0.4
0.01
1
0.01
1
80
165
80
175
30
35
UNITS ♦ CONDITIONS
V
♦ Regulator Shutdown
V
♦ Regulator Enabled
µA
♦ V_IL < 0.4V
µA
♦ V_IH > 1.6V
µs
I_OUT=50mA
µs
I_OUT=100µA
I_OUT=100mA
Note 1. Exceeding the absolute maximum rating may damage the device.
Note 2. The device is not guaranteed to function outside its operating rating.
Note 3. The maximum allowable power dissipation at any T_A (ambient temperature) is P_{D (MAX)} = (T_J – _(MAX) T_A) / θ_JA.
Exceeding the maximum allowable power dissipation will result in excessive die temperature, and the
regulator will go into thermal shutdown. The θ_JA of the SP6213/4 (SC-70-5) is 330°C/W mounted on a PC
board with minimum copper area (see “Thermal Considerations” section for further details).
Note 4. Output voltage temperature coefficient is defined as the worst case voltage change divided by the total
temperature range.
Note 5. Load Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts
are tested for load regulation in the load range. Changes in output voltage due to heating effects are
covered by the thermal regulation specification.
Note 6. Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below
its nominal value measured at 0.5V differential. Not applicable to output voltages less than 2.7V.
Note 7. Ground pin current is the regulator quiescent current. The total current drawn from the supply is the sum
of the load current plus the ground pin current.
Note 8. Thermal regulation is defined as the change in output voltage at a time ”t” after a change in power
dissipation is applied, excluding load or line regulation effects. Specifications are for a 100mA load pulse
at V_IN = 6V for t = 10ms.
Note 9. Devices are ESD sensitive. Handling precautions are recommended.
PIN NUMBER
1
2
3
4
5
PIN NAME
V_IN
GND
EN
NC
V_OUT
PIN DESCRIPTION
SP6214 DESCRIPTION (FUNCTION)
Supply Input
Ground Connection
Enable / Shutdown (Logic high=enable; logic low = shutdown)
No Connection
Regulator Output
PIN NUMBER
1
2
3
4
5
PIN NAME
EN
NC
GND
V_OUT
V_IN
SP6213 DESCRIPTION (FUNCTION)
Enable / Shutdown (Logic high=enable; logic low = shutdown)
No Connection
Ground Connection
Regulator Output
Supply Input
Date: 12/13/05
SP6213, SP6214 Micropower, SC-70, 100mA CMOS LDO Regulator
3
© Copyright 2005 Sipex Corporation