SP6213 Datasheet, PDF (2/10 Pages) Sipex Corporation – Micropower, SC-70, 100mA CMOS LDO Regulator

Supply Input Voltage (V_IN)...................................-2V to 7V
Output Voltage (V_OUT)...............................-0.6 to (V_IN +1V)
Enable Input Voltage (V_EN).............................-2V to 7V
Power Dissipation (P_D)............Internally Limited, Note 3
Lead Temperature (soldering 5s)..........................260°C
Storage Temperature............................-65˚C to +150˚C
ABSOLUTE MAXIMUM RATINGS (Note 1)
(Note 1) These are stress ratings only and functional
operation of the device at these ratings or any other
above those indicated in the operation sections of the
specifications below is not implied. Exposure to absolute
maximum rating conditions for extended periods of time
may affect reliability.
Input Voltage (V_IN) ................................... +2.5V to +6V
Enable Input Voltage (V_EN) ...................... ZeroV to +6V
Junction Temperature (T_J) ................. -40˚C to +125˚C
OPERATING RATINGS (Note 2)
Thermal Resistance ................................... (Note 3)
SC-70-5 (θ_JA) .............................. 330°C/W
ELECTRICAL CHARACTERISTICS
V_IN = V_OUT +0.5V, I_L = 100µA, C_IN = 1µF, C_OUT = 1µF, T_J = 25^°C , unless otherwise noted. The ♦ denotes the specifications which apply over the full
operating temperature range, unless otherwise specified.
PARAMETER
MIN TYP MAX UNITS ♦ CONDITIONS
Output Voltage Accuracy, (V_OUT)
-2.5
-4
2.5
4
%
Variation from specified V_OUT
♦
Output Voltage Temperature
Coefficient, Note 4, (∆V_OUT/∆T)
Minimum Supply Voltage
60
2.50 2.70
2.55 2.85
2.75 3.00
Line Regulation, (∆V_OUT/ V_IN)
SP6213-1.8V Line Regulation
0.05 0.2
0.05 0.2
Load Regulation, Note 5, (∆V_OUT)
SP6213-1.8V Load Regulation
0.4 0.8
0.4 0.8
Dropout Voltage, Note 6, (V – V )
IN
OUT
0.25 4
130 250
250 500
Quiescent Current, (I_GND)
0.01
1
65 125
Ground Pin Current, Note 7, (I_GND)
65 125
100 175
135 250
Power Supply Rejection Ratio,
74
(PSRR)
40
Current Limit, (I_CL)
Thermal Limit
120 190 350
168
153
ppm/
°C
V
%/V
%/V
%
%
mV
mV
mV
µA
µA
µA
µA
dB
mA
°C
I_OUT = 100µA
I_OUT = 50mA
I_OUT = 100mA
♦ V_IN = (V_OUT + 0.5V) to 6V
♦ V_IN = 2.8V to 6V
♦ I_L = 0.1mA to 100mA, V_IN = V_OUT +1V
♦ I_L = 0.1mA to 100mA, V_IN = 3.0V
♦
I
L
=
100µA
♦ I_L = 50mA
♦ I_L = 100mA
♦ V_EN ≤ 0.4V (Shutdown)
♦ V_EN ≥ 1.6V (Operating), I_L = 0µA
♦ V_EN ≥ 1.6V, I_L = 100µA
♦ V_EN ≥ 1.6V, I_L = 50mA
♦ V_EN ≥ 1.6V, I_L = 100mA
Frequency = 100Hz, I_L = 10mA
Frequency = 400kHz, I_L = 10mA
♦
Turns On
Turns Off
Thermal Regulation, (∆V_OUT/∆P_D),
Note 8
0.05
%/W
Output Noise (e_NO)
250
µVrms
I_L=50mA, C_L=1µF, 10Hz to 100kHz
Date: 12/13/05
SP6213, SP6214 Micropower, SC-70, 100mA CMOS LDO Regulator
2
© Copyright 2005 Sipex Corporation