XRP7708 Datasheet, PDF (24/27 Pages) Exar Corporation – Quad Channel Digital PWM Step Down Controller

XRP7708
Quad Channel Digital PWM Step Down Controller
2
∆
Here, ΔV = V_os − V_out is the overshoot voltage deviation.
Select ESR such that output voltage ripple (Vrip) specification is met. There are two components in
Vrip. First component arises from the charge transferred to and from Cout during each cycle. The
second component of Vrip is due to the inductor ripple current flowing through the output
capacitor’s ESR. It can be calculated for Vrip:
1
8
Where:
Irip is the inductor ripple current
fs is the switching frequency
Cout is the output capacitance
Note that a smaller inductor results in a higher Irip, therefore requiring a larger Cout and/or lower
ESR in order to meet Vrip.
• Input Capacitor Selection
Select the input capacitor for Voltage, Capacitance, ripple current, ESR and ESL. Voltage rating is
nominally selected to be at least twice the input voltage. The RMS value of input capacitor current,
assuming a low inductor ripple current, can be approximated as:
1
Where:
Iin is the RMS input current
Iout is the DC output current
D is the duty cycle
In general, the total input voltage ripple should be kept below 1.5% of VIN. The input voltage
ripple also has two major components: the voltage drop on the main capacitor ΔV_Cin and the
voltage drop due to ESR - ΔV_ESR . The contribution to Input voltage ripple by each term can be
calculated from:
Δ V_Cin
=
I V _{out out} (V_in − V_out )
f _s C_inV_in²
ΔV_ESR = ESR ⋅ (I_out + 0.5I_rip )
Total input voltage ripple is the sum of the above:
© 2010 Exar Corporation
24/27
Rev. 1.0.3