EHP-A22-KM35H-P01-35K Datasheet, PDF (23/29 Pages) Everlight Electronics Co., Ltd – LM-80 Certified

DATASHEET
EHP- A22
1W/5S Series
Soldering Ion for Reflow Process
 EHP-A22 series are suitable for SMT process.
 Curing of glue in oven must be according to standard operation flow processes.
 Reflow soldering should not be done more than twice.
 In the soldering process, stress on the LEDs during heating should be avoided.
 After soldering, do not warp the circuit board.
Soldering Ion for Manual Soldering Process
 For prototype builds or small series production runs it is possible to place and solder the
LEDs by hand.
 Dispense thermal conductive glue or grease on the substrates and follow its curing
specifications. Gently press LED housing to closely connect LED and substrate.
 It is recommended to hand solder the leads with a solder tip temperature of 280°C for less
than 3 seconds, at a time and with a soldering iron of less than 25W. Solder at intervals of
two seconds or more.
 Take caution and be aware that damaged products are often a result of improper hand
soldering techniques.
Revis₂io₃n Cop:yr7ight © 2011, Everlight All Rights Reserved. Release Date: Aug.15.2013. Issue RNoe: lDeHaEs-0e00D18a1t1e:2013-08-_w2_w8 _w13_.e:_v1_e5_r:_l4_ig3_h.0_t.com
LifecyclePhase:
Expired Period: Forever