DS_FT231X Datasheet, PDF (8/44 Pages) List of Unclassifed Manufacturers – Future Technology Devices International Ltd FT231X

FT231X USB TO FULL HANDSHAKE UART IC
Datasheet
Version 1.2
Document No.: FT_000565 Clearance No.: FTDI# 261
Pin No.
Name
Type
Description
9
USBDM
INPUT USB Data Signal Minus.
8
USBDP
INPUT USB Data Signal Plus.
11
RESET#
INPUT
Table 3.2 Common Function pins
Reset input (active low).
Pin No. Name Type
Description
17
TXD
Output Transmit Asynchronous Data Output.
1
RXD
Input Receiving Asynchronous Data Input.
19
RTS# Output Request to Send Control Output / Handshake Signal.
6
CTS#
Input Clear To Send Control Input / Handshake Signal.
18
DTR# Output Data Terminal Ready Control Output / Handshake Signal.
4
DSR#
Input Data Set Ready Control Input / Handshake Signal.
5
DCD# Input Data Carrier Detect Control Input.
2
RI#
Input ^{Ring Indicator input for remote wake up.}
Configurable CBUS I/O Pin. Function of this pin is configured in the
15
CBUS0
I/O device MTP memory. The default configuration is TXDEN. See CBUS
Signal Options, Table 3.7.
Configurable CBUS I/O Pin. Function of this pin is configured in the
14
CBUS1
I/O device MTP memory. The default configuration is RXLED#. See CBUS
Signal Options, Table 3.7.
Configurable CBUS I/O Pin. Function of this pin is configured in the
7
CBUS2
I/O device MTP memory. The default configuration is TXLED#. See CBUS
Signal Options, Table 3.7.
Configurable CBUS I/O Pin. Function of this pin is configured in the
16
CBUS3
I/O device MTP memory. The default configuration is SLEEP#. See CBUS
Signal Options, Table 3.7.
Table 3.3 UART Interface and CBUS Group (see note 1)
Notes:
1 When used in Input Mode, the input pins are pulled to VCCIO via internal 75kΩ
(approx) resistors. These pins can be programmed to gently pull low during USB
suspend (PWREN# = “1”) by setting an option in the MTP memory.
Copyright © 2013 Future Technology Devices International Limited
8