3406-3000 Datasheet, PDF (8/9 Pages) List of Unclassifed Manufacturers – designed for IDC (Insulation Displacement Connector) connection with 1.27mm pitch flat cable

JNPS-0846
6-3 ELECTRICAL SPECIFICATIONS
TEST
DESCRIPTION
DIELECTRIC
WITHSTANDING
VOLTAGE
REQUIREMENT
TEST CONDITION
No appearance of arcing
and break down.
Leak current: 1mA Max.
Impressed voltage is AC 1000V rms.
between adjacent two contacts for one
minute.
INSULATION
RESIDENSE
1000MΩ Min.
Impressed voltage is DC 500V between
adjacent two contacts for one minute.
CONTACT
RESISTANCE
- Initial /
25 mΩ Max.
- Change of contact
resistance after
environmental tests /
20 mΩ Max.
Contact resistance is measured
at Short Circuit.
Current: 1.5mA
Open Circuit Voltage: 20mV
by 4 terminal method.
* Measurement values include
the resistance of contact pins
as conductive material.
* Refer to Table 1 regarding the conditions
of each environmental test.
RELATED
STANDARD
――――
――――
See Table 1.
Table 1: ENVIROMENTAL TEST
ITEM
TEST CONDITION
MOISTURE
-10 ∼ 65°C, Relative Humidity 95% / 10 cycles
SALT SPRAY
NaCl 5% solution, 35°C / 48 hours
THERMAL SHOCK _{-55°C→25°C→85°C→25°C / 5 cycles}
HUMIDITY
(STEADY STATE)
40°C, Relative Humidity 95% / 96 hours
THERMAL LIFE
H₂S GAS
Steady Current: Current Rating × 110%, 85°C / 1000 hours
3 ± 1 ppm, 40°C, Relative Humidity 70 ∼ 80% / 96 hours
RELATED STANDARD
MIL-STD-202F106D
MIL-STD-202F101D
MIL-STD-202F107G
MIL-STD-202F103B
――――
JEIDA-38-1984
7. PLATING SPEC INDICATION ON CONNECTOR
The first letter, in stamped 3 letters on the connector body for lot numbering, identified the following
plating specs.
N XX or n XX : PR plating
C XX or c XX : SC plating
S XX or s XX : S plating
* XX : two alphabet letters
8. PACKAGE & IDENTIFICATION
These products are packed with plastic tray and carton box for transit.
Carton box are identified by part number, quantity, maker name and lot number.
９