3406-3000 Datasheet, PDF (7/9 Pages) List of Unclassifed Manufacturers – designed for IDC (Insulation Displacement Connector) connection with 1.27mm pitch flat cable

6. QUALITY PERFORMANCE
6-1 RATING
ITEM
CURRENT
VOLTAGE
TEMPERATURE
JNPS-0846
RATING
1.0A Max.
AC: 250V Max. / DC: 300V Max.
-55°C ~ 105°C
6-2 PHYSICAL SPECIFICATIONS
* The value in ( ) is reference.
TEST
DESCRIPTION
VIBRATION
MECHANICAL
SHOCK
SOLDERABILITY
SOLDERING HEAT
RESISTANCE
REQUIREMENT
Electrical discontinuity:
Less than 1µs
Electrical discontinuity:
Less than 1µs
Wetting: 95% Min.
or
Zero cross time:
3 seconds Max.
Connector should not have
any defect portions after test.
TEST CONDITION
RELATED
STANDARD
Sweep Freq.: 10∼55Hz, Amplitude:
1.52mm(or 98 m/s²), Sweep Cycle:
1min., Sweep time: 2 hours Sweep in
each direction: (X,Y,Z)
490 m/s², 11ms, Half sine shock pulse.
3 times / X,Y,Z directions (Total 18
times)
Solder: Sn-3Ag-0.5Cu
- Wetting Measurement:
245°C, 3 seconds
- Wetting Balance Method:
245°C
Dip soldering:
260°C, 10 seconds, 2 times or
263°C, 5 seconds, 2 times
* without Pre-heating
Soldering Iron:
Dependence on soldering conditions.
* It need the evaluation
under actual conditions.
MIL-STD-
202F 101A
MIL-STD-
202E 213B
JNTM-0039
JIS C 0050
JNTM-0040
８