N76E885 Datasheet, PDF (70/196 Pages) List of Unclassifed Manufacturers – Microcontroller

N76E885 Datasheet
Transmission is initiated by any writing instructions to SBUF. Transmission takes place on TXD pin.
First the start bit comes out, the 8-bit data and bit TB8 (SCON.3) follows to be shifted out and then
ends with a stop bit. After the stop bit appears, TI will be set to indicate the transmission complete.
While REN is set, the reception is allowed at any time. A falling edge of a start bit on RXD will initiate
the reception progress. Data will be sampled and shifted in at the selected baud rate. In the midst of
the stop bit, certain conditions should be met to load SBUF with the received data:
1. RI (SCON.0) = 0, and
2. Either SM2 (SCON.5) = 0, or the received 9th bit = 1 while SM2 = 1 and the received data matches
“Given” or “Broadcast” address. (For enhancement function, see 14.7 “Multiprocessor
Communication” and 14.8 “Automatic Address Recognition”.)
If these conditions are met, the SBUF will be loaded with the received data, the RB8(SCON.2) with the
received 9th bit and RI will be set. If these conditions fail, there will be no data loaded and RI will
remain 0. After above receiving progress, the serial control will look forward another 1-to-0 transition
on RXD pin to start next data reception.
14.4 Mode 3
Mode 3 has the same operation as Mode 2, except its baud rate clock source uses Timer 1 overflows
as its baud rate clocks. See Figure 14-3 for timing diagram of Mode 3. It has no difference from Mode
2.
14.5 Baud Rate
The baud rate source and speed for different modes of serial port is quite different from one another.
All cases are listed in Table 14–3. The user should calculate the baud rate according to their system
configuration.
In Mode 1 or 3, the baud rate clock source of UART0 can be selected from Timer 1 or Timer 3. User
can select the baud rate clock source by BRCK (T3CON.5). For UART1, its baud rate clock comes
only from Timer 3 as its unique clock source.
Dec. 21, 2015
Page 70 of 196
Rev. 1.01