AS5510-DWLT Datasheet, PDF (7/29 Pages) List of Unclassifed Manufacturers – Linear Hall Sensor with IC Output

AS5510 − Electrical Characteristics
Figure 9:
Electrical Characteristics I²C
CMOS I²C: SDA, SCL
Operating conditions: Tamb = -30°C to +85°C, VDD = 2.5V to
3.6V (3V operation) unless otherwise noted.
Symbol
Parameter
V_IL
LOW-level input voltage
V_IH
HIGH-level input voltage
V_hys Hysteresis of Schmitt Trigger inputs
LOW-level output voltage
V_OL
(open-drain or open-collector) at
3mA sink current
I_OL
LOW-level output current
t_of
Output fall time from V_IHmax to
V_ILmax
t_SP
Pulse width of spikes that must be
suppressed by the input filter
I_i
Input current at each I/O pin
C_B
Total capacitive load for each bus
line
C_I/O
I/O capacitance (SDA, SCL) ⁽⁴⁾
Conditions
VDD > 2.5V
VDD > 2.5V
VOL = 0.4V
Min
-0.5
0.7 * VDD
0.05 * VDD
20
-10
Max
Units
0.3 * VDD
V
VDD +0.5V
V
V
0.4V
V
mA
120 ⁽¹⁾
ns
50 ⁽²⁾
ns
+10 ⁽³⁾
μA
550
pF
10
pF
Note(s) and/or Footnote(s):
1. In Fast-mode Plus, fall time is specified the same for both output stage and bus timing. If series resistors are used this has to be
considered for bus timing.
2. Input filters on the SDA and SCL inputs suppress noise spikes of less than 50 ns.
3. I/O pins of Fast-mode and Fast-mode plus devices must not obstruct the SDA and SCL lines if VDD is switched OFF.
4. Special purpose devices such as multiplexers and switches may exceed this capacitance due to the fact that they connect multiple
paths together.
ams Datasheet
[v1-06] 2014-Oct-30
Page 7
Document Feedback