W77L516A Datasheet, PDF (56/89 Pages) List of Unclassifed Manufacturers – 8-BIT MICROCONTROLLER

W77L516A
WATCHDOG TIMER
The Watchdog timer is a free-running timer which can be programmed by the user to serve as a
system monitor, a time-base generator or an event timer. It is basically a set of dividers that divide the
system clock. The divider output is selectable and determines the time-out interval. When the time-out
occurs a flag is set, which can cause an interrupt if enabled, and a system reset can also be caused if it
is enabled. The interrupt will occur if the individual interrupt enable and the global enable are set. The
interrupt and reset functions are independent of each other and may be used separately or together
depending on the users software.
0
Clock Source
Mode input
div. by 4
osc/1
div. by 64 osc/16
div. by 1024 osc/256
Reset Watchdog
RWT (WDCON.0)
16
17 19
20 22
23 25
WD1,WD0
00
01
10 _Time-out
11
WDIF
EWDI(EIE.4)
WTRF
512 clock
delay
Enable Watchdog timer reset
EWT(WDCON.1)
Interrupt
Reset
Figure 19. Watchdog Timer
The Watchdog timer should first be restarted by using RWT. This ensures that the timer starts from a
known state. The RWT bit is used to restart the watchdog timer. This bit is self clearing, i.e. after writing
a 1 to this bit the software will automatically clear it. The watchdog timer will now count clock cycles.
The time-out interval is selected by the two bits WD1 and WD0 (CKCON.7 and CKCON.6). When the
selected time-out occurs, the Watchdog interrupt flag WDIF (WDCON.3) is set. After the time-out has
occurred, the watchdog timer waits for an additional 512 clock cycles. If the Watchdog Reset EWT
(WDCON.1) is enabled, then 512 clocks after the time-out, if there is no RWT, a system reset due to
Watchdog timer will occur. This will last for two machine cycles, and the Watchdog timer reset flag
WTRF (WDCON.2) will be set. This indicates to the software that the watchdog was the cause of the
reset.
When used as a simple timer, the reset and interrupt functions are disabled. The timer will set the
WDIF flag each time the timer completes the selected time interval. The WDIF flag is polled to detect a
time-out and the RWT allows software to restart the timer. The Watchdog timer can also be used as a
very long timer. The interrupt feature is enabled in this case. Every time the time-out occurs an interrupt
will occur if the global interrupt enable EA is set.
The main use of the Watchdog timer is as a system monitor. This is important in real-time control
applications. In case of some power glitches or electro-magnetic interference, the processor may begin
to execute errant code. If this is left unchecked the entire system may crash. Using the watchdog timer
interrupt during software development will allow the user to select ideal watchdog reset locations. The
code is first written without the watchdog interrupt or reset. Then the watchdog interrupt is enabled to
identify code locations where interrupt occurs. The user can now insert instructions to reset the
watchdog timer which will allow the code to run without any watchdog timer interrupts. Now the
- 56 -