PICASO Datasheet, PDF (5/24 Pages) List of Unclassifed Manufacturers – Embedded Graphics Processor

4D SYSTEMS
4. Pin Configuration and Summary
PICASO Processor
PICASO Processor Pin Out
Pin Symbol I/O Description
1
IO1 I/O General Purpose IO1 pin. This pin is 5.0V tolerant.
2
XR
A
4-Wire Resistive Touch Screen Right signal. Connect this pin to XR or X+
signal of the touch panel.
3
YU
A
4-Wire Resistive Touch Screen Up signal. Connect this pin to YU or Y+ signal
of the touch panel.
4
SCK
O
SPI Serial Clock output. SD memory card use only. Connect this pin to the SPI
Serial Clock (SCK) signal of the memory card.
5
SDI
I
SPI Serial Data Input. SD memory card use only. Connect this pin to the SPI
Serial Data Out (SDO) signal of the memory card.
6
SDO
O
SPI Serial Data Output. SD memory card use only. Connect this pin to the SPI
Serial Data In (SDI) signal of the memory card.
7
RESET I Master Reset signal. Connect a 4.7K resistor from this pin to VCC.
8
SDCS
O
SD Memory-Card Chip Select. SD memory card use only. Connect this pin to
the Chip Enable (CS) signal of the memory card.
9, 20, 25, 41 GND
P Device Ground.
10, 19, 26,
38, 57
VCC
P Device Positive Supply.
I = Input, O = Output, P = Power, A = Analogue
© 2012 4D SYSTEMS
Page 5 of 23
www.4dsystems.com.au