PICASO Datasheet, PDF (22/24 Pages) List of Unclassifed Manufacturers – Embedded Graphics Processor

4D SYSTEMS
16. Specifications and Ratings
PICASO Processor
ABSOLUTE MAXIMUM RATINGS
Operating ambient temperature ................................................................................................... -40°C to +85°C
Storage temperature ........................................................................................................................ -65°C +150°C
Voltage on VCC with respect to GND ................................................................................................. -0.3V to 4.0V
Maximum current out of GND pin .............................................................................................................. 300mA
Maximum current into VCC pin .................................................................................................................. 250mA
Maximum output current sunk/sourced by any pin .................................................................................... 4.0mA
Total power dissipation ................................................................................................................................. 1.0W
NOTE: Stresses above those listed here may cause permanent damage to the device. This is a stress rating only
and functional operation of the device at those or any other conditions above those indicated in the
recommended operation listings of this specification is not implied. Exposure to maximum rating conditions
for extended periods may affect device reliability.
Parameter
Supply Voltage (VCC)
Operating Temperature
External Crystal (Xtal)
Input Low Voltage (VIL)
Input High Voltage (VIH)
Input High Voltage (VIH)
RECOMMENDED OPERATING CONDITIONS
Conditions
VCC = 3.3V, all pins
VCC = 3.3V, non 5V tolerant pins
All GPIO pins, RX0 and TX0 pins
Min
3.0
-40
--
VGND
0.8VCC
0.8VCC
Typ
3.3
--
12.00
--
--
--
Max
3.6
+80
--
0.2VCC
VCC
5.5
Units
V
°C
Mhz
V
V
V
GLOBAL CHARACTERISTICS BASED ON OPERATING CONDITIONS
Parameter
Supply Current (ICC)
Internal Operating Frequency
Output Low Voltage (VOL)
Output High Voltage (VOH)
A/D Converter Resolution
Capacitive Loading
Capacitive Loading
Flash Memory Endurance
Conditions
VCC = 3.3V
Xtal = 12.00Mhz
VCC = 3.3V, IOL = 3.4mA
VCC = 3.3V, IOL = -2.0mA
XR, YU pins
CLK1, CLK2 pins
All other pins
PmmC Programming
Min
Typ
Max
--
50
90
--
48.00
--
--
--
0.4
2.4
--
--
8
--
10
--
--
15
--
--
50
--
10000
--
Units
mA
Mhz
V
V
bits
pF
pF
E/W
© 2012 4D SYSTEMS
Page 22 of 23
www.4dsystems.com.au