ICM80000 Datasheet, PDF (5/8 Pages) List of Unclassifed Manufacturers – MODEL ICM8 – ETHERNET GATEWAY

ICM8 PORT PIN OUTS
1 COMMON
2 24VDC ±10%
3 N/C
POWER
CONNECTOR
USB/PG
RS232
RS232/PG PORT
RS485
COMMS
PORT
PORT
STS
USB/PG
RS232/PG
RS485
ETHERNET
ETHERNET
(NIC)
TROUBLESHOOTING
1. This module is designed to operate with Red Lion panel meters only.
Please make sure a Red Lion product is connected to either one of the
two serial ports for the gateway to be active.
2. The Ethernet port is equipped with data LEDs. If they are blinking,
the converter is active and the data is available at the port. Please
verify the receiving equipment is properly programmed.
3. If for any reason you have trouble operating, connecting, or simply
have questions concerning your new ICM8, contact Red Lion’s
technical support. For contact information, refer to the back page of
this bulletin for phone and fax numbers.
EMAIL: [e-mail]
Web Site: http://www.redlion.net
COMMUNICATING WITH THE ICM8
CONFIGURING THE ICM8
The ICM8 is configured using Crimson software. Crimson is available as a
free download from Red Lion’s website, or it can be ordered on CD. Updates to
Crimson for new features and drivers are posted on the website as they become
available. Crimson software can configure the ICM8 through the RS232/PG
port or USB/PG port. The USB/PG port is connected using a standard USB
cable with a Type B connector.
The driver needed to use the USB port will be installed with Crimson. The
RS232/PG port uses a programming cable made by Red Lion to connect to the
DB9 COM port of your computer. If making your own cable, refer to the “ICM8
Port Pin Outs” for wiring information.
ETHERNET COMMUNICATIONS
Ethernet communications can be established at either 10 BASE-T or 100
BASE-TX. The Crimson manual contains additional information on Ethernet
communications.
RS232 PORTS
The ICM8 has one RS232 port. The port can be used for programming or
communications.
ICM8 RS232/PG PORT
CTS
Rx
COMM
COMM
Tx
RTS
RECEIVING DEVICE
DB9
TXD
DTE
3
RXD
2
COMM
5
RS485 PORT
The ICM8 has one RS485 port.
ICM8 COMMS PORT
NC
NC
COMM
A (+)
B (-)
NC
RECEIVING DEVICE
B (-)
A (+)
COMM.*
* OPTIONAL
Note: All Red Lion devices connect A to A and B to B.
5