AMW006 Datasheet, PDF (5/32 Pages) List of Unclassifed Manufacturers – Embedded Wi-Fi Networking Solutions

General Description, Section 1
AMW006 / AMW106 • Embedded Wi-Fi Networking Solutions
1 General Description
The AMW006 and AMW106 modules from ACKme Net-
works combine a microcontroller with a BCM43362 Wi-
Fi device to provide an advanced stand-alone Wi-Fi and
networking solution.
The term AMWx06 refers to both modules.
An integrated module avoids difficult RF layout and ena-
bles designers to rapidly embed Wi-Fi and secure net-
working functionality into virtually any device.
The ACKme Networks WiConnect serial-to-Wi-Fi applica-
tion, pre-programmed into all modules, may be used to
fast-track module integration into end-products.
With dimensions of just 20.3mm x 15.2mm and a wide
temperature range, the module is suitable for integra-
tion into most embedded applications.
The Wi-Fi device from Broadcom includes an integrated
RF transmit power amplifier and provides superior Wi-
Fi performance and full compatibility with all 2.4GHz
802.11b/g/n Wi-Fi networks. Connections for two exter-
nal antennas provide applications with maximum radio
range and mechanical design flexibility.
The microprocessor is based on a high-performance
ARM® 32-bit Cortex™-M4.
The AMW006/AMW106 microcontroller core operates
at a frequency up to 84/100MHz providing up to 125
DMIPS or 1.25 DMIPS/MHz (Dhrystone 2.1).
The AMW006 has 96KB of RAM.
The AMW106 has 128KB of RAM.
The AMWx06 module offers extensive I/O and periph-
eral interfaces listed below, and provides
additional interface combinations by leveraging
multiplexing and alternate function capabilities.
 2 x 4-Wire UART interfaces
 2 x SPI interfaces (1 master, 1 slave)
 21 x GPIOs
 9 x 12-bit A/D converters
 14 x PWM outputs
 1 x ultra-low power wake input
The module is powered by a 3.3V power supply, a sepa-
rate WLAN power supply pin is provided to minimize
noise coupling into the WLAN subsystem.
Various powersave modes offer ultra-low power opera-
tion. Wake from low power sleep mode is possible using
IO pins or the internal real-time clock, and wake from ul-
tra-low power standby mode is achieved using the dedi-
cated wake pin.
The module incorporates a 32.768kHz crystal to main-
tain an accurate real time clock. A 32kHz clock output is
available on a dedicated module pin in both active power
save modes. The 32kHz clock output may be used to
drive the clock input of other system devices. This avoids
the need for an additional crystal thereby minimizing to-
tal system cost.
The module has FCC & IC modular approval for use in the
United States and Canada, CE approval for use in Europe,
TELEC/MIC approval for use in Japan and related approv-
als for use in other countries.
ADS-MWx06-106R • Preliminary Data Sheet
©2014-2015 ACKme Networks. http://ack.me
September 1, 2015
Page | 1