SM5812 Datasheet, PDF (4/4 Pages) List of Unclassifed Manufacturers – Amplified Pressure Sensor

SM5812/SM5852
ADDITIONAL INFORMATION
Package Dimensions & Pin-Out
Dual Inline Pin (DIP) Option
Pin Numbers
(for both DIP & Surface Mount)
PIN DESCRIPTION
1 NC
2 GROUND
3 NC
4 SERIAL DATA (SDA)
5 SERIAL CLOCK (SCL)
6 NC
7
Vexc = 5.000 VDC
8 ANALOG OUTPUT
NOTES:
• Do not connect to NC pins.
• External connections to NC pins will
cause part malfunction.
• All dimensions are shown in inches.
• Tolerance on all dimensions
+0.005” unless otherwise specified.
Surface Mountable Pin Option
Ordering Information
Pin Configuration
3 : DIP pins, opposite direction of tubes
5 : Surface mountable pins,
opposite direction of tubes
Model Number
Pin Configuration
Tube Length
L : Long (0.480" ± 0.005")
N : No tube
Pressure Type
A : Absolute (1 port)
D : Differential (2 ports)
G : Gauge (1 port)
S : Single-ended (2 ports)
SM5852 - 003 - D - 3 - L
Pressure Pressure
Range
Type
Tube
Length
Notes
1. Absolute configuration only available in SM5822.
2. Single-ended configuration is for higher gain differential applications where differential pressure
is always positive.
3. Other configurations available on large orders. Consult SMI for details.
Wiring Diagrams
V_exc = + 5.000 VDC
ANALOG OUTPUT
Full-Scale Pressure Ranges
SM5812 PSI [kPa] SM5852 PSI [kPa]
005
5 [34.5] 001 0.15 [1.0]
015
15 [103.4] 003 0.30 [2.1]
030
30 [206.8] 008 0.80 [5.5]
060
60 [413.7] 015 1.50 [10.3]
100 100 [689.5] 030 3.00 [20.7]
V_exc = + 5.000 VDC
SERIAL CLOCK (SCL)
100 nF
SM5812/SM5852
100 nF
SM5812/SM5852
SERIAL DATA (SDA)
GROUND
GROUND
GROUND
GROUND
Wiring diagram for analog output
Wiring diagram for digital output
Notice:
Silicon Microstructures, Inc. reserves the right to make changes to the product contained in this publication. Silicon Microstructures, Inc. assumes no responsibility for the
use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement.
While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies.
Silicon Microstructures, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably
be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications.
Rev 1.4 6_05
 2005 SMI
Silicon Microstructures, Inc. ♦ 1701 McCarthy Blvd. ♦ Milpitas, CA 95035 ♦ USA
Tel: [phone] ♦ Fax: [phone] ♦ [e-mail] ♦ www.si-micro.com