QBED8145 Datasheet, PDF (4/6 Pages) List of Unclassifed Manufacturers – 5mm IR emitter

QBED8145
5mm IR emitter
Solder Profile & Footprint:
A. Soldering
1. When soldering, the soldering iron needs to be at least 2mm away
from the epoxy edge. After soldering, allow at least 3 minutes for
LEDs to cool back to normal temperature. Do not apply any
pressure to the epoxy encapsulation or the lead frame during the
soldering process.
2. When reflow soldering or wave soldering, please solder once for
less than 5 seconds at a maximum temperature of 260°C. During the
soldering process, if the temperature or timing is not controlled
within limits, it would cause the epoxy to deform or cause the die or
wires within the LED to be damaged.
WAVE SOLDERING PROFILE FOR LEAD FREE PROCESS:
Product: QBED8145
Date: 06/03/2011
Version# 1.0
Page 4 of 6