70207 Datasheet, PDF (4/4 Pages) List of Unclassifed Manufacturers – LINEARlight MULTI FLEX Long life: Up to 50,000 hours

Assembly Information
For complete installation requirements, refer to the LINEARlight MULTI FLEX User Guide
Precautions
1. The LED module will not stretch like ordinary rubber. Stretching will cause damage to the internal circuits.
2. Do not pull on the lead wires as there is risk of damage to the circuit.
3. Bending of the module can be accomplished only at the spaces between the LED. Avoid strained angles. Do not bend the
LED module in the vertical axis.
4. Apply even force over the entire LED module when inserting into an aluminum channel.
Power Supply Selection
1. Refer to the section Power Supply Ordering Information for identification of the power supply requirement for a specified
LED load.
2. The LINEARlight MULTI FLEX requires a 24Vdc Power supply. Each LED module has a maximum load rating of 6 watts. Do
not operate an LED load in excess of the capacity of the power supply.
Electrical Connection
1. The LED module is equipped with polarized wires (red – positive, black – negative). Connect the low voltage load side of
the power supply to the LED module ensuring correct polarity of the electrical connection. Crimp style or wire nut may be
used along with insulating tape or shrink tubing.
2. Up to 3 LED modules can be connected in series to a single power feed connection. For large installations, connect
multiple (3 module sets) in parallel.
Cutting
1. Cutting the LINEARlight MULTI FLEX LED module is possible every 6 LEDs. Please refer to the LINEARlight MULTI FLEX User
Guide for the exact location.
2. Apply silicone sealant after cutting the module.
3. Each module can be cut into no more than two workable sections. You must maintain the end sections with the existing
leads. Middle sections without leads cannot be used.
Definition of a UL 2108 listed Low Voltage Lighting System as it pertains to this module includes: 1. A UL Listed Class 2 power
supply. 2. An appropriate number of SYLVANIA’s LINEARlight MULTI FLEX LED modules based on the recommended max number
of modules listed. 3. Splice connectors/cable systems. 4. Mounting channel.
The power supply must be mounted, wired, and grounded in accordance with all applicable NEC and ANSI standards.
All modular connections on the secondary side of the power supply must be made using an appropriate UL rated splice
connection means. This connection means must be rated for the environment it is installed into. If additional wires and/or
splice connections are necessary, wires are to be UL Listed and splice connectors must be UL rated and chosen of appropriate
size for number and size of wires to be connected. WARNING: the low voltage secondary circuit shall not be grounded.
This information shall not supersede the requirement to follow all other safety, assembly and any other instructions listed in
this document.
OPTOTRONIC is a registered trademark of OSRAM GmbH.
SYLVANIA is a registered trademark of OSRAM SYLVANIA Inc.
Specifications subject to change without notice.
United States
OSRAM SYLVANIA
100 Endicott Street
Danvers, MA 01923
Trade
Phone:
Fax:
1-800-255-5042
1-800-255-5043
National Accounts
Phone: [phone]
Fax:
1-800-562-4674
OEM/Special Markets
Phone: [phone]
Fax:
1-800-762-7192
Display/Optic
Phone: [phone]
Fax:
1-800-762-7192
Canada
OSRAM SYLVANIA LTD.
2001 Drew Road
Mississauga, ON L5S 1S4
Trade
Phone:
Fax:
1-800-263-2852
1-800-667-6772
OEM/Special Markets/Display/Optic
Phone: [phone]
Fax:
1-800-667-6772
www.sylvania.com