RFM12B_15 Datasheet, PDF (35/41 Pages) List of Unclassifed Manufacturers – Universal ISM Band FSK Transceiver

Sensitive Reset Enabled, Ripple on Vdd:
RFM12B
Vdd
1.6V
H
nRes
output
L
Sensitive reset disabled:
Reset threshold voltage
(600mV)
Reset ramp line
(100mV/ms)
time
Vdd
250mV
H
nRes
output
L
Reset threshold voltage
(600mV)
Reset ramp line
(100mV/ms)
time
Software reset
Software reset can be issued by sending the appropriate control command (described at the end of the section) to the chip. The
result of the command is the same as if power-on reset was occurred but the length of the reset event is much less, 0.25ms typical.
The software reset works only when the sensitive reset mode is selected.
Vdd line filtering
During the reset event (caused by power-on, fast positive spike on the supply line or software reset command), it is very important to
keep the Vdd line as smooth as possible. Noise or periodic disturbing signal superimposed the supply voltage may prevent the part
getting out from reset state. To avoid this phenomenon use adequate filtering on the power supply line to keep the level of the
disturbing signal below 100mV p-p in the DC – 50kHz range for 200ms from Vdd ramp start.. Typical example when a switch-mode
regulator is used to supply the radio, switching noise may be present on the Vdd line. Follow the manufacturer’s recommendations
how to decrease the ripple of the regulator IC and/or how to shift the switching frequency.
Related control commands
FIFO and Reset Mode Command
Setting bit<0> to high will change the reset mode to normal from the default sensitive.
SW Reset Command
Issuing FE00h command will trigger software reset (sensitive reset mode must be enabled). See the Wake-up Timer
Command.
35
Tel: [phone] Fax: [phone] E-mail: [e-mail] http://www.hoperf.com