NPC-100 Datasheet, PDF (3/4 Pages) List of Unclassifed Manufacturers – NovaSensor Disposable Medical Pressure Sensors

+In
Pinout
1 +In
2 +Out
3 -Out
4 -In
12 3 4
.069 in (1.75 mm)
0.000 in (0 mm)
+Out
-Out
1. Tolerance on electrical pad location is ±0.010 in (±0.25 mm).
2. Contact pads are suitable for soldering.
3. Split pads on +Out and –Out must be connected for proper operation.
4. All dimensions assume a nominal 0.01 in (0.25 mm) distance between the
edge of the solder pads to the edge of the ceramic. This distance will vary
NPC-100 Series electrical interface
4.35 in (110.5 mm)
0 in (0 mm)
-In
NPC-100 Series schematic diagram
Ordering Information
The code number to be ordered may be specified as follows:
NPC-100
NPC-120
Code
T
Blank: Sold in 120-Up Snapstrate
Tape and reel
NPC-1 0 - ___
Typical model number
1. Sensors are shipped as 120 UP snapstrates that must be singulated by the
customer.
2. Each reel or plate may include units that have failed visual or electrical
parameters as well as good units. Bad units are identified with a dot on the
backside of the cell location.
3. Reels and plates are shipped in dust free anti-static containers to prevent
contamination of the gel surface.
NPC-100 Series shipping Configuration