3011R-17X-0001 Datasheet, PDF (3/3 Pages) List of Unclassifed Manufacturers – enGage II Temperature Monitor

Installation Procedure
1. Mount unit in standard SAE round cutout.
2. Connect supply voltage to pins indicated:
(V+) pin 4, (V-) pin 8.
3. Connect pin 6, as appropriate for key switch, to
enable gauge display.
4. Connect pin 5 as appropriate to input resistance
based senders.
5. Connect pin 3 as appropriate to activate the hour
meter.
6. Connect pin 7 to an appropriate controller for audio,
visual, horn, or other warning device (load). Caution:
Max current draw on warning device is 0.5 Amps.
Installation
Caution!
Bracket has been designed to remain
secured to the gauge upon proper
installation. Once installed correctly, attempts
to remove bracket from gauge may result in
damage to the bracket.
Curtis enGage™ II instruments are mounted
in a 52mm round cutout. Serrations on the
barrel of the gauge, combined with the
mounting bracket provided, insure fast and
trouble free installation. To insure proper
installation, the 2 locking tabs on either side
of the inner diameter of the bracket should
align with the serrations on the barrel of the
gauge (see drawing above). Next, slide the
bracket over the barrel of the gauge and
press it firmly against back of panel. You
should hear the tab sliding over the
serrations.
Curtis enGage™ II mates with an 8-pin AMP
connector (AMP pins P/N 770904-X FOR
#18-24 AWG P/N 794821-1). A
preassembled mating connector kit (Curtis
P/N 17633308-03=AMP) with crimp-connect
terminated wires (approx. 127mm in length) is
also available.
Output and Warning LED
Function
LED
Activated
Temperature
RMB
FET
Opens
RMB
KEY
1. RMB = Right Most LCD Bar
2. LMB = Left Most LCD Bar.
3