3011R-17X-0001 Datasheet, PDF (2/3 Pages) List of Unclassifed Manufacturers – enGage II Temperature Monitor

Maintenance
The enGage™II 3000 Series is not serviceable.
Safety Instructions
 This instrument was manufactured and tested
according to the applicable technical standards. It
complies with all the safety regulations as shipped
from the factory.
 Installation and startup must be performed by skilled
personnel.
 Failure to install and operate the unit in accordance
with these instructions may result in damage or injury.
 If safe operation of the instrument can no longer be
ensured, stop and secure it against accidental
operation.
 If instrument failure or malfunction may cause
personal injury or material damage, use additional
safety measures such as limit switches, guards, etc.
 Read the Operating Instructions carefully before
startup.
 Note the safety instructions marked with this
warning symbol in this manual.
Guarantee
Curtis Instruments’ products and/or components are
guaranteed against defects in workmanship and
material for a period of two years, or as defined in the
individual product literature, from date of shipment
from our factory, when applied in a proper application
within specified ratings. This guarantee is limited to
repair or replacement F.O.B. our factory. There is no
further warranty or implied representation, guarantee,
promise or agreement as to any Curtis Instruments
product and/or component. Curtis Instruments, Inc.,
cannot assume responsibility or accept invoices for
unauthorized repairs to its products and/or
components, even though defective. In no case will
Curtis Instruments’ responsibility extend to products,
components or equipment not of its manufacture.
Under no circumstances shall Curtis Instruments, Inc.
be liable for any special or consequential damages or
loss of profits or other damages. Returned goods will
not be accepted unless identified by a Curtis Return
Material Authorization (RMA). All specifications are
subject to change without notice.
Sender Troubleshoot
Temperature Function
Problem
Possible Cause
No Display
Terminals not connected.
Improper voltage.
Stays At High
Instrument voltage does not
match battery voltage. V+
connected to wrong terminal.
Stays At Low
Instrument voltage does not
match battery voltage. V+
connected to wrong terminal
Notes
1. Mating connector; 8-pin AMP, P/N 794821-1
with UL rating 94V-0. Interface seal, P/N
794772-0. Wire seal 794758-1, Pins
P/N770904-X for #18-24 AWG.
2. Material: Case-polycarbonate, lens-clear
polymethylmethacrylat (PMMA) cover,
overlay and mounting bracket-polycarbonate.
3. This unit is designed for a mounting panel
thickness of 0.8mm-6.4mm.
4. Panel cutout: 52mm diameter dash panel
hole.
2