ZSSC3008 Datasheet, PDF (23/47 Pages) List of Unclassifed Manufacturers – Sensor Signal Conditioner with Diagnostics

ZSSC3008
Sensor Signal Conditioner with Diagnostics
Figure 3.1 General Working Mode
Power ON
Command
Window (3 ms); Send
Start_CM
Start_CM
No Command
Normal Operation Mode
No commands possible.
Measurement cycle.
Conditioning calculations
(corrected bridge).
Depending on the
configuration, the Sig^TM pin is
- 0 V to 1 V,
- Rail-to-rail ratiometric, or
- Digital output.
Diagnostic functions.
Start_NOM
Command Mode
Measurement cycle stopped.
Full command set.
Command routine will be
processed after each
command.
Start_RM
Raw Mode
Measurement cycle.
Sig^TM pin provides raw bridge
data in the format:
- Bridge_high (1^st byte)
- Bridge_low (2^nd byte)
Error Detection
Diagnostic
State*
Power OFF
* See section 2.6.
Data Sheet
June 14, 2011
© 2011 Zentrum Mikroelektronik Dresden AG — Rev. 1.11
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without
the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without notice.
23 of 46