SM5108 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – Ultra-Small, Low-Cost,OEM Pressure Die

SM5108
CHARACTERISTICS FOR SM5108 - SPECIFICATIONS
All parameters are measured at 5.000V supply at room temperature, unless otherwise specified.
Min.
Typ.
Max.
Units
Notes
Excitation Voltage
0
Excitation Current
0
Span (FS Range)
15 PSI 65
30 PSI 65
60 PSI 65
150 PSI 100
Offset
-35
TC Span
-24
TC Offset
-7
TC Resistance
+24
Linearity
-0.2
Bridge Impedance
4
Input Capacitance
Proof Pressure
3X
Burst Pressure
5X
Operating Temperature
-40
Storage Temperature
-55
5.0
1.5
100
100
100
150
-19
-1
+27.5
-0.07
5
<2
15
V
1
2.5
mA
1
2
135
mV
135
mV
135
mV
200
mV
35
mV
-15.5
%FS/100°C
3
+7
%FS/100°C
3
+33
%/100°C
3
+0.2
%FS
4
6
kΩ
pF
Rated FS
Rated FS
+125
°C
+150
°C
Notes:
1. Bridge may be driven with positive or negative excitation; positive output for positive pressure applied to circuit side of die
when bridge is driven with positive voltage.
2. Measured at 5V constant voltage excitation.
3. Measured from 0 to 70 C
+ Sig
+Vexc
4. Defined as best straight line.
ORDERING INFORMATION:
Pressure Ranges
PSI 5108
15 015
30 030
60 060
150 150
A: Absolute (only)
- Vexc - Vexc
- Sig
Top-View of SM5108
(0.65 mm square as sawn)
Total thickness = 0.65 mm
Notice:
Covered under USA Mask-Copyright
Silicon Microstructures, Inc. reserves the right to make changes to the product contained in this publication. Silicon Microstructures, Inc. assumes no responsibility for the use of any
circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this
publication has been checked, no responsibility, however, is assumed for inaccuracies.
Silicon Microstructures, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to
cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications.
Rev 1.3 6_05
© 2003 - 2004
Silicon Microstructures, Inc. ♦ 1701 McCarthy Blvd. ♦ Milpitas, CA 95035 USA
Tel: [phone] ♦ Fax: [phone] ♦ [e-mail] ♦ www.si-micro.com