|
SM5108 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Ultra-Small, Low-Cost,OEM Pressure Die | |||
|
SILICON
MICROSTRUCTURES
INCORPORATED
SM5108
Ultra-Small, Low-Cost,
OEM Pressure Die
⢠For Extremely High-Volume Applications
⢠Ultra-Small, Low Cost OEM Pressure Die
DESCRIPTION
The SM5108 is a extremely small (0.65 mm
x 0.65 mm) silicon micromachined
piezoresistive pressure sensing chip that
has been optimized to provide the highest
possible accuracy for a die of this size. This
performance is achieved through careful
resistor placement and mechanical
configuration. The small die results in a
significant cost saving when compared to
larger sensor die. Over 24,000 die come on
a 150 mm wafer.
This sensor is intended for high volume
applications where cost is a critical factor,
such as consumer tire pressure gauges or
disposable pressure gauges. The SM5108 is
available as an absolute pressure sensor in
full-scale ranges of 15 PSI, 30 PSI, 60 PSI,
and 150 PSI. It is designed to be mounted
on ceramic or PC board substrates by high-
volume OEM manufacturers.
Die are probed, diced, and visually
inspected and shipped on tape in rings.
Custom pressure ranges are available in
high-volume applications.
Minimum order quantities apply to this
product.
FEATURES
⢠Available in 15 PSI, 30 PSI, 60 PSI, and
150 PSI ranges
⢠Extremely Low Cost
⢠Small size (0.65 mm square)
⢠Constant Current or Constant Voltage
Drive
⢠High Millivolt Output
APPLICATIONS
⢠Automotive Tire Pressure Monitoring
⢠Engine Control
⢠Barometric Sensing
⢠Pneumatic Gages
⢠Hand-held Meters
⢠Home Appliances
Rev 1.3 6_05
© 2003 - 2004
Silicon Microstructures, Inc. ⦠1701 McCarthy Blvd. ⦠Milpitas, CA 95035 USA
Tel: 408-577-0100 ⦠Fax: 408-577-0123 ⦠sales@si-micro.com ⦠www.si-micro.com
|
▷ |