CPCI-7300 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – 80 MB/s High-Speed 32-CH Digital I/O Cards

High-Speed DIO
Specifications
Digital I/O
■ Numbers of channel (Software configurable)
• 16 DI & 16 DO
• 32 DI
• 32 DO
■ Compatibility: 5 V/TTL
■ Digital logic levels
• Input high voltage: 2-5.25 V
• Input low voltage: 0-0.8 V
• Output high voltage: 2.7 V minimum
• Output low voltage: 0.5 V maximum
■ Input load
• Terminator OFF
- Input high current: 1 mA
- Input low current: 20 mA
• Terminator ON
- Termination resistor: 111 Ω
- Termination voltage: 2.9 V
- Input high current: 1 mA
- Input low current: 22.4 mA
■ Output driving capacity
• Source current: 8 mA
• Sink current: 48 mA
Transfer Characteristics
■ Data transfers:
Bus-mastering DMA with Scatter/Gather
■ Data width: 32/16/8 bits (programmable)
Data Transfer Count
■ 2 M double words (8 MB) for non-chaining
mode DMA
■ No limitation for chaining mode (scatter/gather) DMA
Max Transfer Rate
■ DO: 80 MBytes/s, 32-bit output @ 20 MHz
DI: 80 MBytes/s, 32-bit input @ 20 MHz
Trigger
■ DI_TRG for digital inputs,
DO_TRG for digital outputs
■ Compatibility: 5 V/TTL
■ Trigger types: rising or falling edges
■ Minimum pulse width: 32 ns
Clocking Mode
■ Internal clock
• Internal clock sources: 20 MHz, 10 MHz, Timer#0
output (digital input pacer) and Timer #1
output (digital output pacer)
■ External clock up to 40 MHz
■ Handshaking
■ Burst handshaking
Programmable Counter
■ Base clock: 10 MHz
■ Timer #0 as digital input pacer
■ Timer #1 as digital output pacer
■ Timer #2: as interrupt source
Auxiliary Digital I/O
■ Number of channels
• 4-CH digital inputs
• 4-CH digital outputs
■ Compatibility: 5 V/TTL
■ Data transfers: programmed I/O
■ I/O connector: One 100-pin SCSI-II female
■ Operating temperature: 0˚C to 60˚C
■ Storage temperature: -20˚C to 80˚C
■ Relative humidity: 5% to 95%, non-condensing
■ Power requirements
Device
Power Onboard
Onboard
terminator off terminator on
PCI-7300A +5 V 830 mA typical 1.0 A typicall
PCIe-7300A ^{+12 V 119 mA typical 287 mA typical}
+3.3 V 499 mA typical 543 mA typical
cPCI-7300 +5 V 830 mA typical 1.0 A typical
■ Dimensions (not including connectors)
• 179 mm x 106 mm (PCI-7300A)
• 168 mm x 112 mm (PCIe-7300A)
• 160 mm x 100 mm (cPCI-7300)
Terminal Boards & Cables
■ DIN-100S-01
Terminal Board with One 100-pin SCSI-II Connector
and DIN-Rail Mounting (Cables are not included.)
Note:
Legacy DIN-502S can be replaced by two DIN-50S-01
and ACL-10252-1 (100-Pin to two 50-Pin Cable, 1 M)
■ ACL-102100-1
100-pin SCSI-II cable (mating with AMP-787082-9), 1 M
* For more information on mating cables, please refer to
P2-61/62.
Ordering Information
■ PCI-7300A
80 MB/S High-Speed 32-CH Digital I/O Card
■ PCIe-7300A
80 MB/S High-Speed 32-CH Digital I/O PCIe Card
■ cPCI-7300
80 MB/s High-Speed 32-CH Digital I/O Module
Pin Assignment
GND 1 51 PB15
GND 2 52 PB14
GND 3 53 PB13
GND 4 54 PB12
GND 5 55 PB11
GND 6 56 PB10
GND 7 57 PB9
GND 8 58 PB8
GND 9 59 PB7
GND 10 60 PB6
GND 11 61 PB5
GND 12 62 PB4
GND 13 63 PB3
GND 14 64 PB2
GND 15 65 PB1
GND 16 66 PB0
GND 17 67 DO_ACK
GND 18 68 DO_REQ
GND 19 69 DO_TRG
GND 20 70 AUXO3
GND 21 71 AUXO2
GND 22 72 AUXO1
GND 23 73 AUXO0
GND 24 74 TERMPWR
GND 25 75 TERMPWR
GND 26 76 TERMPWR
GND 27 77 TERMPWR
GND 28 78 AUXI3
GND 29 79 AUXI2
GND 30 80 AUXI1
GND 31 81 AUXI0
GND 32 82 DI_ACK
GND 33 83 DI_REQ
GND 34 84 DI_TRG
GND 35 85 PA15
GND 36 86 PA14
GND 37 87 PA13
GND 38 88 PA12
GND 39 89 PA11
GND 40 90 PA10
GND 41 91 PA9
GND 42 92 PA8
GND 43 93 PA7
GND 44 94 PA6
GND 45 95 PA5
GND 46 96 PA4
GND 47 97 PA3
GND 48 98 PA2
GND 49 99 PA1
GND 50 100 PA0
Updated 03-28, 2012. ©2012 ADLINK Technology, Inc. All Rights Reserved. All specifications are subject to change without further notice.
www.adlinktech.com ^2-42