APSDM002G15AN-AT Datasheet, PDF (2/21 Pages) List of Unclassifed Manufacturers – SATA-Disk Module 4

SATA-Disk Module 4
APSDMxxxx15Ax-AXX
Features:
z Standard Serial ATA 2.6 (Gen. 2)
– Serial ATA 2.6 (Gen. 2)
– SATA II, 3.0 Gbps
– ATA-compatible command set
z Capacities
– 2, 4, 8, 16, 32, 64 GB
z Performance*
– Burst read/write: 300 MB/sec
– Sustained read: up to 165 MB/sec
– Sustained write: up to 150 MB/sec
z Intelligent endurance design
– Built-in hardware ECC, enabling up to
16/24 bit correction per 1K bytes
– Static wear-leveling scheme together
with dynamical block allocation to
significantly increase the lifespan of a
flash device and optimize the disk
performance
– Flash bad-block management
– S.M.A.R.T.
– Power Failure Management
– ATA Secure Erase
– TRIM
z NAND Flash Type: SLC
z Zero power data retention
– No battery required for data storage
z Temperature ranges
– Operation: 0°C to 70°C (32 ~ 158°F)
– Extended: -40 ~ +85°C (-40° ~ 185°F)
– Storage: -40°C to 100°C (-40° ~ 212°F)
z Supply voltage
– 5.0 V ± 5%
z Power consumption (typical)*
– Active mode: 333 mA@5.0 V
– Idle mode: 95 mA@5.0 V
z Connector type
– 7-pin SATA signal connector
– 15-pin SATA power connector
z Form factor
– SATA Disk Module (44 x 30 x 1.6, unit: mm)
z Shock & Vibration
– Shock: 50g (approx.)
– Vibration: 15g (approx.)
z MTBF: >2,000,000
z RoHS compliant
*Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations
or platform settings. The term idle refers to the standby state of the device.
1
© 2011 Apacer Technology Inc.
Rev. 1.0