586-102111-2 Datasheet, PDF (2/3 Pages) List of Unclassifed Manufacturers – Water resistant Double-make or double-break contacts

TYPE 586 PART NUMBERING SYSTEM
586 – x xx x x x - x
Basic Part Number Series
Mounting
Coil
Voltage/Duty
Coil
Termination
Bracket
1 – Standard bracket
Contact
02 – 6 Volt continuous
1 – Isolated
Form
1 – SPNO
3 – SPDT
05 – 12 Volt continuous
08 – 15 Volt continuous
14 – 24 Volt continuous
16 – 28 Volt continuous
Contact
Material
Factory Assigned Specials
(where undefined, contact factory)
No dash – Standard assem-
17 – 36 Volt continuous
1 – AgCdO
bly, hardware sent bulk
20 – 48 Volt continuous
2 – Customer requested
markings
3 – Customer requested
markings
3A – Customer requested
APPLICATION NOTES
markings
• Not all part number combinations are available. Please contact your Sales Representative for
available part numbers.
• Solenoids applied in battery charging circuits should be protected from higher than rated
voltage during charging. The service life may be affected by this condition and the solenoid
5 – Customer requested
markings
6 – Customer requested
markings
6A – Customer requested
may or may not operate the circuit as intended.
markings
• Circuits should be designed to provide safe operation should the solenoid fail in either the
open or closed position.
7 – Customer requested
markings
NORMALLY
CLOSED
SPDT – Isolated Coil
.281 WIDE X .640 LONG SLOT
.594
NORMALLY
OPEN
1.156
W 3.300
2.300
L
4.618
5/16-24 UNF-2A X .594 LONG
1.375
#10-32 UNF-2A X .375 LONG
H 2.797
1.274
CIRCUIT DIAGRAM
SPNO – Isolated Coil
.281 WIDE X .640 LONG SLOT
.594
NORMALLY
OPEN
1.156
W 3.300
2.300
L
3.688
5/16-24 UNF-2A X .594 LONG
1.375
#10-32 UNF-2A X .375 LONG
H 2.797
1.274
CIRCUIT DIAGRAM
R-4005C
1232