BXRA-35E4000 Datasheet, PDF (13/24 Pages) List of Unclassifed Manufacturers – Bridgelux RS Array Series

Mechanical Dimensions
Figure 1: Drawing for RS Arrays
Notes for Figure 1:
1. Slots are for M2.5, M3 or #4 screws.
2. Solder pads are labeled “+” and “-“ to denote positive and negative, respectively.
3. It is not necessary to provide electrical connections to both sets of solder pads. Either set of
solder pads (6.35 x 2.03 mm rectangular pads or 3.50 mm tapered square pads) may be used
depending on application specific design requirements.
4. Drawings are not to scale.
5. Drawing dimensions are in millimeters.
6. Bridgelux recommends four tapped holes for mounting screws – refer to product Application Note
AN11 for recommended spacing of holes.
7. Unless otherwise specified, tolerances are ± 0.10 mm.
8. Refer to product Application Notes AN10 and AN11 for product handling, mounting and heat sink
recommendations.
9. The optical center of the LED Array is defined by the mechanical center of the array.
10. Bridgelux maintains a flatness of 0.25 mm across the mounting surface of the array. Refer to
Application Notes AN10 and AN11 for product handling, mounting and heat sink
recommendations.
Bridgelux RS Array Series Product Data Sheet DS25 (12/3/11)
Page 13 of 24